Search results

Search the forum Search Articles
  1. DPC

    Transmission options

    duraflite/allison I just looked at the 10.99 and quicker list, did not realize how many duraflites were out there. http://www.duramaxdiesels.com/forum/showthread.php?t=23137&highlight=top+50+duramax+list&page=86 I have checked into duraflite prices and they are not cheap, not sure what a...
  2. DPC

    Transmission options

    I have a few questions for transmissions options in a possible super street truck 1. With advances in tech on the Allison will it hold 9.XX passes for a race season, or will tear downs be needed every few races? 2. If the Allison can be made reliable on 9.XX passes what kind of costs are...
  3. DPC

    Red Alto or Rybestos

    So Alto for C1s and GPZs for C2,3,and 4s?
  4. DPC

    Learning to tune with EFI

    The EFILive fourm helped me out, most of the time I could just do a search and find what I needed to know. Lots of good tuning info on that site, diesel and gas.
  5. DPC

    Front ends

    I have this on my truck with the 1480 yoke, no issues. You do not need the balancer with this yoke. FYI it is about 1 inch taller than the stocker.
  6. DPC

    RCV performance cv axles

    As far as strength goes I believe CumminsKiller runs them on his 3.0 truck...at least at TS he had them, couldn't believe a 3.0 truck was still running IFS, highly modified IFS.
  7. DPC

    Ennis tx

    I am going to try and make it down Saturday, it is about a 4 hour drive for me.
  8. DPC

    Allison whining 3-4 shift

    Have you checked the pressure readings?
  9. DPC

    Help 01 LB7 Wont go past 2000rpm

    Do you have a lift pump on it?
    • DPC
    • Post #2
    • Forum: LB7
  10. DPC

    Allison whining 3-4 shift

    How long ago was your tranny built? Check the cooler fittings on the side of the transmission to make sure they are tight.
  11. DPC

    HELP: Eliminating hard fuel lines

    Two feed lines. One to each CP3?
    • DPC
    • Post #17
    • Forum: LBZ
  12. DPC

    HELP: Eliminating hard fuel lines

    Advantage? BLUF: Does any of this have a HP advantage or it this just for cosmetic reasons? The factory feed line is a 1/2 inch, are folks running out of fuel because of the fuel line size? I did some research on the fittings and lines and you can spend a ton of money on this if you...
    • DPC
    • Post #15
    • Forum: LBZ
  13. DPC

    Oklahoma Newb

    Welcome from Elgin, OK.
  14. DPC

    Garrett GTX4508R

    If you are going to DD and tow I would use the 4508 in a twin setup with the stocker, no way would I use it as a singel unless is was strickly a play truck.
  15. DPC

    Hello from Oklahoma

    Welcome from Elgin.
  16. DPC

    Cylinder bore repair?

    Wagler had cylinder sleeves on display at TS, and from what I was told they are in a high horsepower 3.0 duramax puller.
  17. DPC

    Rear Diff. Gasket.

    And reusable. Sent from my iPhone using Tapatalk
    • DPC
    • Post #12
    • Forum: LB7
  18. DPC

    Erratic line pressure

    http://www.merchant-automotive.com/p-2678-dowel-pin-transmission-to-engine.aspx
  19. DPC

    Erratic line pressure

    Mike, thanks for the advise, o-ring was damaged. Tranny shifts great and no codes! Sent from my iPhone using Tapatalk
  20. DPC

    Erratic line pressure

    P1713 New pump, new filter, line pressure problem solved. Now I have a P1713 (Trans pressure switch, reverse circuit) problem. When I put it in reverse it commands reverse and then 1-2 seconds later it actually goes into reverse and the shift indicator starts flashing. Shift into drive...
Top Bottom