Search results
-
P
v2 as codereader?
quick question- can I use my v2 to read and clear DTC on vehicles not supported by EFI live? I just tried to read the codes on a coworkers Toyota Tacoma, and it keeps saying "no DTCs" but the CEL is illuminated -
P
New high capacity trim valve springs
I might have missed it, but these can be installed without dropping the valve body correct?- Porno Joe
- Post #70
- Forum: Mike L's Trans Talk
-
P
Need a rebuild in ohio!
If Caleb is closest drive to him. I've had one of his built trans in my truck for shit, I think coming up on 3 years this June. ZERO issues- Porno Joe
- Post #24
- Forum: Mike L's Trans Talk
-
P
Best type of coolant
x2 always seem to have to drain it and spill some of it so just use the cheapest stuff I can find- Porno Joe
- Post #31
- Forum: Fluids and Maintenance
-
P
Broke off fuel test port
sub'd pretty good ideas in here. I've been thinking about cleaning up my fuel lines a bit. -
P
New high capacity trim valve springs
Subd. I need a set of these- Porno Joe
- Post #55
- Forum: Mike L's Trans Talk
-
P
2002 LB7 Voltage Issues
does the entire radio reset- ie all the presets are gone too -or is it solely the clock? everything else you described is normal except for the radio. would almost make me wonder if something in the radio isn't bad -
P
5hp 220v compressor motor issue
every time I have ever had an issue with my compressor, its been the capacitors- Porno Joe
- Post #9
- Forum: Smoke Signals
-
P
LLY: headgasket replacement
my instruction sheet for ARP I did a few weeks ago said 3 equal steps to 125. When I torqued and let them sit overnight, I had none that needed retorqued -
P
Body Control Module
I could be wrong, but isn't the bcm up under the dash on the drivers side -
P
Turbo coolant line after vvt removal
simpliest method, and one I did first was just run a loop of hose in place of the lines that went to the stock charger. IMHO, and the "most correct" way is what I have now- fleece billet plug for the thermostat housing.upper hose and I removed that pipe in the pic above, and cut off the...- Porno Joe
- Post #6
- Forum: Turbo Talk
-
P
are valve cover gaskets reusable?
Good. Pass side all went in fine drivers rear I used the trick I read on here( I think hondarider) and jacked up the rear of the trans and got it in with a little wiggling. -
P
are valve cover gaskets reusable?
Yup amazing how much quieter it is now -
P
are valve cover gaskets reusable?
Well got it all done Kind of a crappy pic Also did head studs and set the valves. I know I've read ppl say that Dmax valves never need adjusted but let me say that at 206k miles I had some way out of adjustment. Some were at 23 thou. -
P
need opinions on tig welders
ok bumping this back up. I ended up picking up the hobart ez tig. Now my question is what other supplies do i need to get? Ive got the tank of argon already. So from reading looks like I need some Tungsten and some filler rod? I know if I want to weld aluminum and steel, i need a...- Porno Joe
- Post #15
- Forum: The Tool Crib