Recent content by MaxPowerLB7

  1. MaxPowerLB7

    need a IT guys help on a winsows table in race car

    The description says it has pass-through capabilities. Which is what your looking for, right?
  2. MaxPowerLB7

    need a IT guys help on a winsows table in race car

    http://www.amazon.com/Motorola-Power-Portable-Battery-Built-In/dp/B00PIVY7E6
  3. MaxPowerLB7

    Accelerator pedal drops out occasionally, P2133 P2139 P2140

    X2 There are redundant circuits in the apps and one is failing.
  4. MaxPowerLB7

    Size differences on BorgWarner vs. Garrett

    T4 S4s and gt42s are close enough they can be bolted in place of each other. The gtx is the same size to as far as I know.
  5. MaxPowerLB7

    Im Back- and looking to DPC 2016

    x2
  6. MaxPowerLB7

    Im Back- and looking to DPC 2016

    I had a good experience at the dpc. I didn't spend much. I drove my competition truck 1700 miles to the event and was lucky enough not to get bit by mechanical failure. I gained a lot of exposure as well. There were some rule changes to let competitors have a shot at a better performance...
  7. MaxPowerLB7

    I messed up!

    Monitor the data with efilive, edge, etc. and put the needles in place to match while at idle.
  8. MaxPowerLB7

    Is a water pump done after the weep hole leaks?

    Yes, it needs to be replaced.
  9. MaxPowerLB7

    Dual Fuel maxing rail at Idle

    Maybe try stock belt and dual controller and see how that behaves.
  10. MaxPowerLB7

    Truck randomly loses power

    I you lost power then the regulator would default open causing high pressure. I would guess its pulling in air through a cracked hose/fitting before the lift pump.
  11. MaxPowerLB7

    Congrats Brett Deutsch on first 8 sec street truck!

    Congratulations! That is a huge achievement! Your perseverance has paid off in a big way!
  12. MaxPowerLB7

    Valve adjustment moving air question.

    Or the glow plugs...
  13. MaxPowerLB7

    Valve adjustment moving air question.

    Air could be leaking past the injectors, injector cups, intake/exhaust valves, or head gaskets. It could also be air escaping past the rings. You should be able to feel if its leaking past the valves or injectors either through the ports or near the injector body if that is the case.
  14. MaxPowerLB7

    Tie rods still bend with sleeves

    Definitely get some braces for the next go round. I have sleeves and braces with stock keys and the bolts removed and have never had an issue. My cv angle is a bit negative as well.
  15. MaxPowerLB7

    Twin turbo cross over pipe

    Yours is 3.5. Llys-lmms were changed, but lb7s dont really give a choice nor is there issues with tight fitment.
See more
Top Bottom