Search results
-
New turbo! Couple questions...
He used to make them. But now Ppe has their own set- Xcav8R
- Post #18
- Forum: Turbo Talk
-
idler pulley part #
I put one of these on a couple months ago. Haven't thrown a belt since -
-
-
-
LB7 won't start
So unhooked driver side battery and it was corroded plus there was some lead on it that shouldn't of been. Cleaned it up and kaboom it starts. Thanks guys -
-
LB7 won't start
So my truck won't turn over. Batteries have over 12 volts each. So story goes like this. I turn key to run a few seconds later dash lights up I have just 9 volts on dash voltmeter. Then a few seconds later I gain a lil more volts. I measured at ignition wires and it is 9.8 volt at red and white... -
-
-
-
Mishimoto Intercoolers
I have a BD and I don't like that it pushes the rad towards engine. Does the mishimoto move the rad?- Xcav8R
- Post #55
- Forum: Duramax Hard Parts
-
Pulling motor and tranny
Well I could of hooked the big hoe on and pulled it out without undoing a bolt lol- Xcav8R
- Post #16
- Forum: Smoke Signals
-
Pulling motor and tranny
Bad ass cherry picker ( I need to mount a swivel hook on quick attach plate)- Xcav8R
- Post #14
- Forum: Smoke Signals
-
-
Allison 5sp: Leaking bellhousing? Maybe?
I don't wanna lol. I will look into this bigger o-ring thanks man- Xcav8R
- Post #3
- Forum: Mike L's Trans Talk
-
Allison 5sp: Leaking bellhousing? Maybe?
Hey guys I am going crazy trying to find this leak. I rebuilt allison and it started leaking a bit. I think it was excess blowing out vent plus it had a constant drip this time(but looked to be gone when I pulled it and did seals). I am running transynd. I took it out once already it was not...- Xcav8R
- Thread
- Replies: 5
- Forum: Mike L's Trans Talk
-
-
Get Tapatalk app for free
Original is free for iOS just downloaded it- Xcav8R
- Post #5
- Forum: Smoke Signals
-
LB7: Head Bolt Taps
Hey guys just wondering what the head bolts thread size's are? I would like to clean the threads with a tap before I put my heads back on. So what I want to know is what size taps do I need? Thank you- Xcav8R
- Thread
- Replies: 2
- Forum: The Tool Crib