Search results

Search the forum Search Articles
  1. smkndmax05

    1/4 mile discussion and time slips post here!

    Thanks Ken Sent from my iPhone using Tapatalk
  2. smkndmax05

    Congrats smkndmax05 10.8

    Never said 6200 Kyle that I know of on here, maybe on FB, the lightest I could be is 6300 with a 1/4 of fuel. It was between 3/4 and full last night. Sent from my iPhone using Tapatalk
  3. smkndmax05

    Congrats smkndmax05 10.8

    Ken. 6400lbs Fleece tuned allison LLY
  4. smkndmax05

    Congrats smkndmax05 10.8

    Pretty impressed with the hoosier tires!!!
  5. smkndmax05

    Congrats smkndmax05 10.8

    Thanks Kat!!!
  6. smkndmax05

    Roll bar time

    Race trim!!! Sent from my iPhone using Tapatalk
  7. smkndmax05

    Roll bar time

    I had about 1700$ in it after the swing outs lexan and safety belts. I didn't think that was to bad.
  8. smkndmax05

    Roll bar time

    I actually drove it in the ran yesterday and had no issues what so ever. I was kinda surprised. The lexan is sitting on a 1/2 inch rubber gasket, and I used some 2.5 inch led light grommets to go around the struts coming out the back. Everything turned out looking good and working as if it...
  9. smkndmax05

    Roll bar time

    It is a 5 point harness, the crotch strap is just bolted through the floor and cross member under the truck. Everything turned out pretty good
  10. smkndmax05

    Roll bar time

    Sent from my iPhone using Tapatalk
  11. smkndmax05

    Roll bar time

    Sent from my iPhone using Tapatalk
  12. smkndmax05

    Roll bar time

    It's started Sent from my iPhone using Tapatalk
  13. smkndmax05

    Mickey Thompson drag radials

    Finally choose the tires. Went with a hoosier 28x14.50 QTP. They weigh exactly 50lbs each on the wheels. Sent from my iPhone using Tapatalk
  14. smkndmax05

    Fleece BILLET 68 Cheetah VGT Testing

    Around 70lbs per the dyno driver..... Sent from my iPhone using Tapatalk
  15. smkndmax05

    Fleece BILLET 68 Cheetah VGT Testing

    1600 degrees at 3500 rpm, peak boost numbers were 50+. It would be fine for a daily driver charger, this is obviously a full out tune on a built motor with 2 pumps and larger injectors. A DD tune would be lower pulse and would run a lot cooler with great driving characteristics. Sent from my...
  16. smkndmax05

    Fleece BILLET 68 Cheetah VGT Testing

    Some huge numbers posted on VGT this week. Give Caleb or Paul a call with any questions. Here is the link to the dyno results. http://youtu.be/y45Cw7Xw9qw Sent from my iPhone using Tapatalk
  17. smkndmax05

    New 2.0 TD Cruze

    See Fleece performance for a emissions friendly tune, it will get rid of the delay factor down low. We are getting 46+ with a tune in ours! Sent from my iPhone using Tapatalk
  18. smkndmax05

    LBZ: Fleece transmission cooler lines

    I have them on my truck. A great product. It's full lines with fittings!! Sent from my iPhone using Tapatalk
  19. smkndmax05

    The Highest Form of Flattery

    Yours is on the right, or are you saying arias copied you? Sent from my iPhone using Tapatalk
  20. smkndmax05

    What pistons for build.

    I bit the bullet, I'm all in for a rollbar and cage to follow if it's fast enough. I would also check into PPE race cast pistons. That's the route I went, I also dropped to 15.5/1 and saw no drivability loss in the awesome Indiana weather....Good luck with your build. Sent from my iPhone...
Top Bottom