"OFFICIAL" What did you do to your D-Max today?
- Thread starter Hot COCOAL
- Start date
What did you not like about the 72?
'06 '07 LBZ's
Owner of ShopSource.com
& Evil Arc Fabrication
Washed the truck after changing injectors and blowing a boost tube 3 times on the test drive. Got it sorted, though.
Sent from my FlashScan V2
Sent from my FlashScan V2
easter breakfast supply run, spanked a 4.6 mustang on the highway, he threw me a thumbs up when he rolled back by. I'm glad people can do a pull and not be sore losers and get bent out of shape. But he had a mustang so he probably already knew it was slow:rofl:
That is a very clean and good looking engine bayWashed the truck after changing injectors and blowing a boost tube 3 times on the test drive. Got it sorted, though.
Sent from my FlashScan V2
Sent from my SM-G900V using Tapatalk
Thanks!
I tried to do something similar last night, but as soon as I hammered down, a boost tube exited stage left, lol. Had to coast to a gas station in defeat.
Sent from my FlashScan V2
How much boost were you making with that 366 I'm guessing? Can't see sigs on my phone but I'm guessing with all the powder that it's built motor and plenty of fuel
Sent from my SM-G900V using Tapatalk
Sent from my SM-G900V using Tapatalk
It is a billet S371 with 75% over sticks. Built internals, ported head, cam, etc. Makes about 45 PSI boost on the current tune. The problem was one of the couplers wasn't long enough and I couldn't get a clamp past the rolled end, so it kept blowing off. Got a better coupler on it and hasn't popped off since.
Sent from my FlashScan V2
I gotcha. My old 366 I hit 48 on the big tune with totally stock internal lbz...scared the poop outta me it was so violent. I miss it haha
Sent from my SM-G900V using Tapatalk
Sent from my SM-G900V using Tapatalk
catman3126
I saw a Chevy HD this weekend that had what looked like the plastic fender trim on it. I don't know if they were aftermarket or factory pieces, but I suspect that you will be able to add something.
I saw a Chevy HD this weekend that had what looked like the plastic fender trim on it. I don't know if they were aftermarket or factory pieces, but I suspect that you will be able to add something.
I SOLD IT! time for a LML :woott: told my GF I would leave the new one alone for 6 months...I will break that promise in 6 minutes
Thanks! Hope the new owner enjoys it as much as I did. Picking up its replacement tomorrow morning :thumb:
Today, I completed my monthly mileage chart at 16,635 miles. Yes, I still have a couple of days left in the month. Tomorrow, I will be replacing the original front wheel bearing/hubs. Every now and then the wheel sensor acts up while braking on very tight twisty roads when lots of braking is used. So, I figure that I will replace the wheel sensors and bearings tomorrow and flush and replace the brake fluid. The stock front bearings have 421,000 miles on them.
Built some Trac Bars for Nightmare. Getting ready for the NHRDA Opener in Phoenix.
No more axle wrap and no issues with suspension travel. They are almost 5' bolt to bolt. Built from some stuff I had laying around the shop.
'06 '07 LBZ's
Owner of ShopSource.com
& Evil Arc Fabrication
No more axle wrap and no issues with suspension travel. They are almost 5' bolt to bolt. Built from some stuff I had laying around the shop.
'06 '07 LBZ's
Owner of ShopSource.com
& Evil Arc Fabrication