"OFFICIAL" What did you do to your D-Max today?

[Parker_]

Installed efi live and ripped on my nieghbours powerchoke


Sent from my iPhone using Tapatalk

 

[superswamper003]

Sort of cleaned the air filter earlier this morning..

 

[Emanlb7]

Rebuilt front diff (had to replace drivers side half since ear was cut off for lift).

Re-wired hack job of running lights and headlights from previous owner.

Re-charged A/C and figured out why compressor wouldn't cut in with out forced command on scanner (low pressure switch no good).

 

[dirtydmax]

Finished the twin's and buggered up the oil filter bracket because of a over torqued filter,Oh ya,installed my hood stack to razz the heat.

 

[minerigger]

Updated some pics of her. From this 9800 lb. pig to this 7800 lb. truck


Then cleaned up under the hood a bit to hide some of the wiring harness and what not.


and installed my crappy turbo blanket...been sitting on the toolbox since November, wish ida known about Levi's before I got this one

 

[superswamper003]

Finally got my running lights working today.. No more rapid blinker anymore! Took me over a year but oh well

 

[Brabham 64]

Paint matched my cheepo camper and mounted her up Sunday!

 

[TROJAN366]

Ditched the stack. Cut my tailpipe and installed a muffler and 6" tip to dump it. Going to spend some time raising the rear hanger at some point but it looks decent for now. Hecl of a lot quieter and made it look like a sleeper.

 

[c20elephant]

TROJAN366, what brand are the traction bar rear links at the leaf spring?

 

[MAXX IT OUT]

I finally "finished" my exterior for my truck, well maybe a roll pan. They sent me the wrong turn signals, so HOPEFULLY they will send me the right ones now. I believe it made my truck looking 10 time better, I just wish i could find a little better quality ones.

 

[TROJAN366]

TROJAN366, what brand are the traction bar rear links at the leaf spring?

I got the entire setup from Tony at all seasons / Dirty Hooker Diesel

 

[kirkland]

Well almost got everything visually done.. Still want to install smoked cab lights and have some one take the reflectors out of a set of headlights

Added N-fab running boards really like they way they look

Sent from my iPhone using Tapatalk

 

[Cornell]

Stripped and painted the frame on the crew cab so it's easier to clean and doesn't hold dust.

 

[minerigger]

What paint did you use? Turned out really good. I'm assuming that's a really new truck

 

[lutzjk913]

What paint did you use? Turned out really good. I'm assuming that's a really new truck

I agree. Turned out nice!

Wander what it looked like before?

 

[bevi]

Debadged and took Z71 off bed sides

 

[Cornell]

What paint did you use? Turned out really good. I'm assuming that's a really new truck

I used Rust Check Stone Shield... I had a case of it shipped from Canada. Stuff is amazing.

I did the frame of my 2007 LBZ. Its never seen winter and has 47k miles on it.

The frame wasn't rusting I just hate how the factory frame coating collects dust and its a pain to clean.

 

[moparkxracer]

Getting close

Day dreamed abt going for a ride...

 

[kirkland]

Well got my exhaust leak fixed.. Thought it was just a gasket never expected this lol and put a 3" down pipe on, the tranny dipstick whooped me

Sent from my iPhone using Tapatalk

 

[hondarider552]

That's what happens when you don't support the up pipe riser. Happened to me years ago.