"OFFICIAL" What did you do to your D-Max today?

ChrisPerry

...........
Apr 4, 2016
209
6
18
Ventura, CA
Are you sure about that I swear they were rated for at least 10,000 pounds?


Sent from my iPad using Tapatalk

I thought so too until I actually read the tag. Still can't believe the hitch is so light weight. I pulled around 12-13000 a few times locally before I knew better. Now that I have a class v, never more than 8000. Go figure.
 

Chevy1925

don't know sh!t about IFS
Staff member
Oct 21, 2009
21,743
5,911
113
Phoenix Az
Put a new FPR in. Ahh there is the nice quiet idle. Glad it was the easy one on the second pump. Also swapped my heater hose from the upper rad hose back to the water pump bypass so I have heat in the morning. It’s a freezing 55-60* out here :rofl: :rofl:

And momma is gone for the week for a school trip so I took over the garage.

32e82cb79ccdf5e96e3ee29cc7b53553.jpg


And a little daddy daughter time mixed in

cdf62982bdb76be4f335202a71679d77.jpg
 

DAVe3283

Heavy & Slow
Sep 3, 2009
3,729
297
83
Boise, ID, USA
Haven't been able to hurt this hitch yet. It goes 6" farther into the frame than stock, and ties into my lift gate for additional strength.

My dad had a trailer rip off his Dodge stock hitch and go through a fence. He keeps putting stock hitches back on for some reason. I learned the lesson for him, and run this custom hitch.
d19ca259de4c5ada89ffd7ffb1ac487a.jpg


Sent from my Cat S60 using Tapatalk
 

Hambone

Always learning
Jan 24, 2016
572
0
16
Florida
Rotating tires and noticed the stock hub cap nuts were lose on the lug nut...
Lil electric tape fixed that problem!
#PoorboywaysIMG_6055.jpg


Sent from my iPhone using Tapatalk
 

Attachments

  • IMG_6055.jpg
    IMG_6055.jpg
    70 KB · Views: 47

lts1ow

Needs moar PAH!
May 14, 2012
1,598
0
36
NJ
Took truck for a alignment while back and along with a $1200 estimate, they said all tie rods are bad and RH upper ball joint is shot.

So, Rockauto to the rescue :D
Yfffp2Ll.jpg


NHDTEIBl.jpg


I should have done this a long time ago, old parts are shoooot
6LpUH5Sl.jpg
 

frankenstien

Member
May 25, 2015
587
2
18
Fairbanks,Alaska
Finished making a new lighter bumper, front end parts should be much happier now. still have to mount my light bar to it

finally got my new wheels and tires on, hopefully get this fuel leek whooped and she will be good to go
 

Attachments

  • truck1.jpg
    truck1.jpg
    128 KB · Views: 46
  • truck2.jpg
    truck2.jpg
    171.4 KB · Views: 43
  • truck3.jpg
    truck3.jpg
    164.9 KB · Views: 43
  • truck4.jpg
    truck4.jpg
    160.5 KB · Views: 39
  • truck5.jpg
    truck5.jpg
    151.1 KB · Views: 40