Ya, I think I might get some 45 deg. fittings so the hose's go through the center of the hole better.
Duramaxzak 2.6 pulling truck build
- Thread starter duramaxzak
- Start date
Ya, I think I might get some 45 deg. fittings so the hose's go through the center of the hole better.
Starting to work on the wiring and wondering what you guys are doing to kill power to the ECM? Is there a power wire I can put a switch in?
Kill switch discussion. We used a trailer breakaway
http://www.duramaxdiesels.com/forum/showthread.php?t=34151
Some people kill the ficm vs ecm so you don't lose your data logging.
https://m.youtube.com/watch?v=xLhNLq02Ad0
Speed up to the 3:00 mark and watch the effectiveness of an air knife that gets accidentally bumped on a dyno run. Are you required to have one of these as well?
http://www.duramaxdiesels.com/forum/showthread.php?t=34151
Some people kill the ficm vs ecm so you don't lose your data logging.
https://m.youtube.com/watch?v=xLhNLq02Ad0
Speed up to the 3:00 mark and watch the effectiveness of an air knife that gets accidentally bumped on a dyno run. Are you required to have one of these as well?
Last edited:
Thanks for the links! I am running a air shut off, but would also like to be able to kill the motor from the cab if need be. I like the idea of tapping into the fuse spot!
Yep, maybe about 3/8" space. When I remove the leaf spring's I can remove the inside 2" wheel spacer.
If you're running 10" Real wheels with 8" back spacing, you can run as small as a 7/8" spacer on the hub. I have a set i do not need any longer if you would like.
Yep, 10" wide with 8" BS Realwheels.
Pm me a price shipped to 55398! Not sure if I'm going to have time to get the rear axle welded in this year.
I bought my 8" BS wheels used with the intent on removing the rear leaf springs and welding the axle in, but am consider leaving the leaf springs on it now.
Because the wheels will work for years to come on any setup now. Spacers are cheap and readily available. Real wheels, not so much. We now run no spacer at all and need a narrower axle:thumb:
I have been tying up alot of loose ends lately. Got all my pumps and fans wired, finished up putting the lids on the weight box it just needs some grinding and a paint job.
View attachment 37889
View attachment 37889
Last edited:
