Search results
-
Wicked Level 3 or LBZ cp3
I would say 600rwhp can be done on a LBZ stock pump with the right setup -
-
LBZ injector tips on a LLY body?
I know lbz/lmm tips will swap- skintback
- Post #2
- Forum: Duramax Hard Parts
-
Question: Are head studs needed with twins?
I would put them in one at a time while you think it's ok after you start to notice that you have a problem you'll have to remove the heads to put new gaskets on that's alot more labor- skintback
- Post #19
- Forum: Turbo Talk
-
LBZ injector tips on a LLY body?
Will lbz tips go on a 05 lly injector body?- skintback
- Thread
- Replies: 2
- Forum: Duramax Hard Parts
-
stock tranny in a 2500 lb project
Put the transgo jr in and tune it to keep the torque down :)- skintback
- Post #4
- Forum: Mike L's Trans Talk
-
Arp main stud torque sequence
I did one cap at a time 90 on the side and 200 on the stud- skintback
- Post #4
- Forum: Duramax Hard Parts
-
-
-
Suncoast dyno day
Good times :D a 6.4 did a little over a 1000 on a small whiff and 600 on #2 wow what a back fire when they tried more juice and ended with a blown head gasket but it was pretty cool to see a ford make that make power :thumb: There was also a built LBZ there that did 950 on the juice...- skintback
- Post #7
- Forum: Dynamometer
-
-
check this idiot out!!!
Thats not to far from my neck of the woods :eek: Very sad- skintback
- Post #16
- Forum: The Comedy Club
-
Air in fuel system?
Whats the IP mod Are the injectors stock May have a injector or two returning to much fuel I know when i had a 1792 the truck would run with it off just not very well not sure if it would suck the line closed try and unplug the FPR and see what it does- skintback
- Post #17
- Forum: Duramax Hard Parts
-
Question: ppe Cp3 pump inlet fitting
Nice i'll have to try that :thumb:- skintback
- Post #29
- Forum: Duramax Hard Parts
-
The Dirty has risen!!!
Feels nice to here them run again :D Congrats- skintback
- Post #3
- Forum: Repower / Transplant
-
New Hot Ford Tunes
The 300+ tunes spartan/sct will do that from what i'v been told and seen :thumb:- skintback
- Post #33
- Forum: Smoke Signals
-
LB7: The Rebuild, Ch.2 -- Building slowly
Take your time it will all work out -
Reman lly injectors?
Where is everybody getting reman lly lbz lmm injectors from and how much? I've been getting them from the dealer for 360 each what a rip off lb7's can be had for 150 what gives :confused: Thank Sonny -
Air Dog Regulator
All the AD1's i have seen and installed only run 10-12psi on the duramax at that low of pressure i see no need for a regulator- skintback
- Post #3
- Forum: Duramax Hard Parts
-