Search results

Search the forum Search Articles
  1. Mogman

    LMM to LBZ?

    So my LMM repower project seems to have hit a few snags and it seems like possibly converting to a LBZ ECM may be easier than the LMM, is this possible and if so what hardware will be needed?
  2. Mogman

    What threads are the cooler fittings?

    THANKS, does it have an oring? like this ORB fitting? EDIT! It looks like 7/8 SAE is 14 TPI.......
  3. Mogman

    What threads are the cooler fittings?

    Sorry, brain fart it is an 08 6 speed Allison 1000, I need to know what the threads in the aluminum case are so I can remove the fittings that use the clips and replace them with 5/8 JIC or 10-AN for you aircraft nuts.
  4. Mogman

    What threads are the cooler fittings?

    What threads are actually in the aluminum housing for the cooler lines? I need to convert them to 5/8 JIC
  5. Mogman

    2006-7 VS 2008 cluster??

    Yep, if true that would mean game over!!
  6. Mogman

    2006-7 VS 2008 cluster??

    I am hoping once again this is the correct forum, I am doing a custom re-power using a 2008 LMM, I want to use the factory cluster as I had seen on another build BUT....... The other build used a 2006 (LBZ?) cluster and there is a difference that would make it MUCH easier to do if I can use a...
  7. Mogman

    Interesting first read!

    I got the error figured out and the speedo and DTC deletes look like other "stock" tunes I have looked at.
  8. Mogman

    Interesting first read!

    SORRY!! 2008 GMC 3500/LMM EDIT, looked at some "stock" tunes and these may be normal
  9. Mogman

    Interesting first read!

    OK I just set up my flash scan, I have not been able to do a write (cal flash) as I get an error "S0311 Mode Not Supported" but I have put that on the EFILive forum to discus, what I am curious about is some of the DTC disables I have found and if they are normal, this of course would be best...
  10. Mogman

    XP? Vista?

    TKS! YAHOO my V2 just came in, not sure what do first, high on the list is figuring out how to kill the air intake heater code, with the check engine light on all the time I am afraid I may miss something important.... AND the remote start/kill does not work, if I clear the code with my old...
  11. Mogman

    XP? Vista?

    So I go to the software installation FAQs and see a link for install instructions for XP and Vista??? are these just way out of date or will EFILive only load on XP and Vista??
  12. Mogman

    Fuel gauge

    I hope this is the correct forum. When I purchased my 2008 3500 it showed a full tank of fuel, when it got down to a 1/4 tank I refilled it but it only took 10 gal to fill up and the gauge is still on 1/4. The DIC says 103 miles to empty. So the question is, if the signal for the gauge is coming...
  13. Mogman

    Obnoxious smell

    I will have my lift cleared by this weekend and can put it up in the air and give it a good looking over.
  14. Mogman

    Obnoxious smell

    I have put several hunred miles on it and it is not using oil or coolant, besides does not smell like any coolant I have ever experienced before
  15. Mogman

    Obnoxious smell

    292K dealer replaced the fresh air intake with factory setup, EGR looks to be intact and unmodified, only codes are the air intake heater, the smell appears to be coming out of the tailpipe
  16. Mogman

    Obnoxious smell

    OK my "new" 2008 GMC 350 emits an obnoxious smell, I can smell it outside the truck from the time I start it until I shut it off, when driving it and come to a stop many times I can smell it, especially driving down wind, it is not the "normal" diesel smell like all my farm machinery emits, it...
    • Mogman
    • Thread
    • Replies: 7
    • Forum: LMM
  17. Mogman

    Q - Does EFILive support ECM output overrides like TechII?A - Yes.

    The owners manual says it was optional , but again it looks like the duallies never had it.
  18. Mogman

    Q - Does EFILive support ECM output overrides like TechII?A - Yes.

    Sorry 2008 GMC 3500HD SLT It looks like the 3500 never had TPMS, sorry my bad, seem stupid as one would think having TPMS on a dually would be important considering it is harder to detect a low tire visually on the duals.
  19. Mogman

    Q - Does EFILive support ECM output overrides like TechII?A - Yes.

    my "new" truck had the aluminum wheels snatched by presumably the dealer, I went through the "information" on the DIC and do not see anything about TPMS and assume they programmed it out at the dealer so other than making sure my wheels are equipped for TPMS how do I re-program the truck for...
  20. Mogman

    Q - Does EFILive support ECM output overrides like TechII?A - Yes.

    Thanks, I assume I have to use the BCM as I would LIKE to use the cluster, that will take quite a bit of jumpering, I assume the messages about ABS come from the TCM while the ones about trailer etc. come from the BCM
Top Bottom