Search results

Search the forum Search Articles
  1. ShredLordXx

    LLY: Need help Engine running in limp!

    Well I ice picked #2, hopefully I went in deep enough, I also added some dielectric grease in the connect, I then drove it around town for about 20 minutes without a hiccup, althought i was able to drive 4 hours last time before it acted up again, I did find that #2 was previously repaired by...
  2. ShredLordXx

    LLY: Need help Engine running in limp!

    I agree with the wiring headache, no it doesn't seem like it did the zip tie around it was not very tight and was nicely sitting in the hose, and not against the alt bracket. You can definately see where it was rubbing on the hose though. it started to idle weird about 4 times, while i was...
  3. ShredLordXx

    LLY: Need help Engine running in limp!

    Well I took the FICM Harness appart tonight, and i don't see any rub through, I tried to push most of the harness connectors on the injectors, and it didn't do anything, while i was on the passenger side, I was moving a wire loom a few times, and it seems i trigger the rough idle it thew codes...
  4. ShredLordXx

    LLY: Need help Engine running in limp!

    I thought of doing the ice pick trick, I cannot see any physical chaffing at the alternator, as it's already wraped in a thick heater hose. I would think if the pigtail was bad on cyl 2 that if i touched it it would go tractor mode no?
  5. ShredLordXx

    LLY: Need help Engine running in limp!

    The Harness at the FICM or at the injector? I will probably tear into both, unless i see them. I played around with cyl 2 connector today, i took it off and put it back on, now it seems my problem is even worse, but if i jiggle the connector and or wire while its running it wont act up, it's...
  6. ShredLordXx

    LLY: Need help Engine running in limp!

    Hi guys, I'm trying to figure out a really bad problem, while driving the engine will throw MIL and fuel tank reading will go to empty, and then I will be in Limp mode, this has happened three times before today, and was simply able to get out of it by restarting my truck, today it seems very...
  7. ShredLordXx

    Cluster problems

    Yeah Stepper Motors, I had my speedometer die on me, while traveling, my tach went as well, replaced all but my battery one, and now it needs to be replaced, as the needle is bottomed right out into the bezel lol, I also changed my lights while I was in there, the only crappy part about the...
  8. ShredLordXx

    LLY: Torsion Bar is broken....

    Good to hear, do you use timbrens or anything of the sort? When i hit bumps my plow frame hits the ground. I may have to turn my torsions up, or get lift keys.
  9. ShredLordXx

    LLY: Torsion Bar is broken....

    Well I think i found my answer, if you click on other suspension parts in gm parts direct i can see the 1Ton torsion bar for the 3500 which is this guy So i guess i definately bought the wrong torsion bar!:mad: Manufacturer: GM Part Number: 19330060 Part: TORSION BAR, LEFT Part Notes: 4WD, 1 TON
  10. ShredLordXx

    LLY: Torsion Bar is broken....

    Yeah I will probably buy some timbrens, to help the sag, but I don't have the donor part in hand yet, just pictures. and I don't see any of those codes on it, I am worried that the donor 2005 avalance 1500 torsion bar will not be good for the 3500, even though they have the same part number on...
  11. ShredLordXx

    LLY: Torsion Bar is broken....

    With a bit of reading though, which really confuses me is that the donor truck is a 2005 Avalanche 1500, and when i looked up part numbers on gmpartsdirect.com they both have the same part number... FRONT SUSPENSION/FRONT SUSPENSION FOR 2004 GMC SIERRA 3500 15528958 TORSION BAR ALL MODELS; 4WD...
  12. ShredLordXx

    LLY: Torsion Bar is broken....

    Then one i ordered is stamped 309 on the back L and the other side is CS 394
  13. ShredLordXx

    LLY: Torsion Bar is broken....

    Crap! I may have gotten the wrong Torsion bar then, I ordered one off of ebay, the Donor truck was an avalanche 1500 and the lists his part will fit these makes and models with these options CHEVROLET 1500 PICKUP 88-98 Front; (model VIN K), L. CHEVROLET 1500 PICKUP 99 Front; (5.0L or...
  14. ShredLordXx

    LLY: Torsion Bar is broken....

    What I found strange, is that my truck which is a 3500 and a chevy avalanche 1500 have the same torsion bars. I'm new to this truck and chev all together, I guess this is normal.
  15. ShredLordXx

    LLY: Torsion Bar is broken....

    I always put my plow down at night, or even take it off, that night the plow was all the way down and I had kept it on because it's snowing all week, I found it weird that it broke then, the bump stop is there its just compressed down to nothing. I've heard people say timbrens are good and bad...
  16. ShredLordXx

    LLY: Torsion Bar is broken....

    Well I'm not sure what caused this but I'm guessing it has to do with my plow I just recently put a Meyer 8.5 straight blade on, and my front end sags quite a bit. When I woke up Saturday and looked outside I saw my truck leaning, and when I went inspected it, I found this on the drivers side...
  17. ShredLordXx

    2004 Gmc 3500

    ShredLordXx submitted a new Showcase Item: 2004 Gmc 3500 Read more about this showcase item here...
  18. 2004 Gmc 3500

    2004 Gmc 3500

    2004 Gmc 3500
  19. ShredLordXx

    LLY: Smell Of Fuel under Hood, Strong on Passenger side

    Took my injector rates, they look good too, I can't get over how hard it is to find this fuel leak :S
  20. ShredLordXx

    LLY: Smell Of Fuel under Hood, Strong on Passenger side

    Fuel was puddled in there, but I changed it, no more leak. The smell is still strong, can't really see any diesel leaks anywhere else, pretty frustrating.
Top Bottom