LBZ: Programming Injector Flow Rate?

[Jose]

These are the ones from a lbz

So the trim code would be 000FA0D000000000. It this correct?

Notice I added three zeros at the end. Do you know what is the reason of this? I think it should cause a lot of misunderstandings...

Thanks guys!

 

[JoshH]

These are the ones from a lbz

Those must be reman injectors.

 

[JoshH]

So the trim code would be 000FA0D000000000. It this correct?

Notice I added three zeros at the end. Do you know what is the reason of this? I think it should cause a lot of misunderstandings...

Thanks guys!

Yes. Add zeros at the end.

 

[Ne-max]

Those must be reman injectors.

Correct. Tops have a X on them.

 

[Jose]

Correct. Tops have a X on them.

Excuse me, What do you mean with "Tops"?

 

[JoshH]

Excuse me, What do you mean with "Tops"?

He's talking about the number in the picture I posted that is on the top of the solenoid. Since they are reman injectors, those codes are no longer valid. They have been marked out by covering each letter/number with an X and a new code has been etched in the side of the injector as shown in his picture rather than on top of the solenoid.

 

[Jose]

Thank you so much guys! :woott: