Search results

Search the forum Search Articles
  1. I

    LBZ: 1st Sled Pull

  2. I

    LBZ: 1st Sled Pull

    The pull this past weekend went much better! It ended up raining for about 30 mins, they re-tilled the track....but still muddy as crap! (BFG's didn't have the bite needed to get descent speed, I think) However the truck stayed planted, once I got to 215ft or so.....pop! Blew the EGT probe out...
  3. I

    LBZ: 1st Sled Pull

    The 1st pull was bad....was getting rear end hopping once the sled started sliding up. Pretty sure was getting too much traction, and too soft of air pressure (38psi rear). The new wheels/tire setup should help. Will find out towards the end of the month!
  4. I

    LBZ: 1st Sled Pull

    I'm switching to AT tires for this reason! On the bold.... IS the hitch height measured from the top or bottom of the loop? My hitch is 1" thick steel.
  5. I

    LBZ: 1st Sled Pull

    I'll try dropping front tire pressure! I was afraid of that......so you think me running in the 7000lb class is going to over then? With no weight I came in at 6800lbs.
  6. I

    LBZ: 1st Sled Pull

    I also think running almost new Toyo MT's weren't helping....just got that solved. Picked up a set of 18x10 MT Classic Lock's with BFG All Terrains with about 35% tread.....not a fan of the look as much now but this should help..... I hope!!
  7. I

    LBZ: 1st Sled Pull

    No worries! I did get to pull. Ended up pulling in both the 7000lb Open and 8000lb Open.....results were the same. Disappointing! Ran Axle stops, front end dropped, and 35psi in front tires, and 38psi in rear. ---each pull ended up with the rear end hopping once the sled started sliding up...
  8. I

    LBZ: 1st Sled Pull

    No it's just a smaller local pull up here in Michigan. Thanks guys, I think this truck will be sticking around for a while with me!
  9. I

    LBZ: 1st Sled Pull

    Well the previous owner just contacted me, I do have 2nd gear start tuned in the TCM!:thumb: I know it's addicting, but I'm only planning on pulling in a few local pulls. I have too many other addictions that suck my $$! :roflmao:
  10. I

    LBZ: 1st Sled Pull

    Thanks guys! I'm really hoping to get some stops built! The class I'm pulling in is 7000lb open, so really anything goes :) I've had the truck for nearly a year already.....but finally the itch to pull is taking over! Tuning was done by Durmaxtuner at a live dyno tuning (both motor and...
  11. I

    LBZ: 1st Sled Pull

    Hey guys-- I'm going to get in my 1st sled pull in about a less than 2 weeks. I want to run over my setup please let me know if I need to change anything...... All Advise welcome :) Truck details below! - Suspension: Kryptonite Center Link & Tie Rods with Cognito Support kits & Cognito Upper...
  12. I

    4" lift on 33's

    So much SEXY in one post! WOW!!!!! Great looking truck! Are those NFab nerf bars? I'm thinking about getting a set for mine!
  13. I

    4" lift on 33's

    They are right, it's a Rancho 4". It is cranked some, and yes bumper is clearanced..... But other than that, just some fender liner trimming.
  14. I

    4" lift on 33's

    Here is a 4" lift on 35's. IMO 33's look too small.....
  15. I

    OK sled heads lets see em

    Here is my setup for this winter. '15 Polaris AXYS Rush 800 Pro X (60th Anniv)
  16. I

    The tale of 2 RC/SB Duramaxes

    Those are cool!!!
Top Bottom