What did you do at work today?
- Thread starter six5creed
- Start date
Clocked out for the last time at the old place. New job starts Wednesday. Hopefully bag and elk or 2 before I go back to work
Sent from my SM-G930V using Tapatalk
Sent from my SM-G930V using Tapatalk
Been working on getting stuff done on my FL60... LMM is loosing oil pressure over last couple weeks, runs ~40psi @2100/210° and 20psi @750rpm/190°
Normal is 35-40/65-70
Min is 7/28 @750/1800rpm
Kicking myself for not putting an oil pump in this spring
Got few more things on the frame to do before putting the 8.3/trans in the FL60.
Normal is 35-40/65-70
Min is 7/28 @750/1800rpm
Kicking myself for not putting an oil pump in this spring
Got few more things on the frame to do before putting the 8.3/trans in the FL60.
Waterproofed shower floor, set shower floor and grouted bathroom floor. Now time to go try and get the dmax running
Sitting in my truck doing paper work and sending a butt load of emails. Hoping we don’t have to move the building on the project I’m stating the dirt work on. Damn architect didn’t look at the foundation plans and existing storm pipe for interference.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
I use to see this stuff all the time, when I was a plumbing contractor. These guys would forget to put things on the plans a lot. Talk about inflated egos. They sure got butt hurt when I called them out on this.
The bad thing was it was on the plans. When I talked to my Project Manager he told me he asked the GC to make sure they had the architect check the clearance. They lucked out though we are just going to make that row spread footings instead of piers.
My guys are almost done. Then we will be on to the next one next week. Just need the damn trucks to hurry up, so I can the beat the rain coming this weekend.
Sent from my iPhone using Tapatalk
Rough mockup of the GN hitch.. just enough room to run 2*2*1/4 tubing underneath when aired out.. got driveshaft installed as well..
Other than making some threaded 2" galvanized nipples in various lengths, not a whole lot. It's not often we have un-threaded pipe laying around to make stuff like that. Usually we just buy it all ready done. This is for water distribution system use on end of the line blow off pipes.
Finished a shower and started another one
Why in the hell is the shower valve on the low pony wall side and the head on the opposite? So you have to turn around to adjust the water and get on your knees.
Why didn't they put it on the same wall?