truck towing pictures...
- Thread starter malibu795
- Start date
Yes I did.. Asked the guys at sarka(manufacturer) about it.. Said the gravel pit asked to do like a 2-3 month trial run.. They used it to beat frozen gravel out of hopper rail road cars. There was one at each end.
Delivering the other one
10,660 tons of junk 300 miles and used 4200 gallons of fuel for 16,600hp.
:bow: you are the tow master
Sticker and plated for 36,000lbs now. Got everything transfer to the new trailer..
First load.. Off to Boston MA area
First load.. Off to Boston MA area
Nice looking new trailer. What happened to the old one? Did you ever get the crack issue corrected?
Sticker and plated for 36,000lbs now. Got everything transfer to the new trailer..
First load.. Off to Boston MA area
Is the new trailer aluminum?
Yes bridged it.. old trailer is in the left of the picture... Keeping it till I get another in my name..
Crossman trailers
http://www.crossmantrailer.com/
Well all this rain keeps the rig somewhat clean
Yes bridged it.. old trailer is in the left of the picture... Keeping it till I get another in my name..
Crossman trailers
http://www.crossmantrailer.com/
Well all this rain keeps the rig somewhat clean
Nice trailer! Is it the same length and deck configuration as your old trailer? What are you initial thoughts about your new trailer?
Alcoa doesn't make 8-6.5 19.5
5' longer fold flat wedge ramps pop up center with sliding winch track. Boss bought it.. Wish I had more say in it.. Had them make the entire neck area a chain locker. Add chain spools.
Absolutely no wet noddle flex when empty
Airride is is by ride well with dump.. But no lift axle. 3gallon air tank and a single valiar 450c compressor... A gauge on the tank and one for suspension pressure word be nice neither of which it has..
Most of the stuff is "I'd do it this way" vs manufacturer lacking stuf..
I will be buying one for myself
Went to adjust the neck.. The 5/8" hitch pin is rotated ~15° off perpendicular of frame line
How's this for bracing
Last edited:
A while back I was looking for some wheels and found out that dealers can order the Alcoa's without bolt holes in them. Don't remember where I found that information though.
I did do a search for wheels and found these at summit.http://www.summitracing.com/parts/aew-0589-9698/overview/
Will keep looking to see if I can find the Alcoa's again.
I did do a search for wheels and found these at summit.http://www.summitracing.com/parts/aew-0589-9698/overview/
Will keep looking to see if I can find the Alcoa's again.
