Damn Josh, just think if that was a paying job... I usually have 5-6 hrs in teardown when I do them(in cab)
Sent from my SM-G900V using Tapatalk
Sent from my SM-G900V using Tapatalk
"OFFICIAL" What did you do to your D-Max today?
- Thread starter Hot COCOAL
- Start date
It's a Fleece CP3K. It flows the same as stock it just has some restrictions removed to keep it from dropping rail higher in the RPM range. I didn't do anything with the heads other than clean them up with a piece of scotch brite and some brake parts cleaner.
I know, right? It's amazing how much easier it is to do this stuff when you lift the cab, and my buddy that helped me out has it down so he can get the cab off in about an hour. It's almost like cheating.
Before and after... Pretty minor compared to a lot of these posts, but I'm happy with the change!
Reno eNVy
Reno eNVy
Before and after... Pretty minor compared to a lot of these posts, but I'm happy with the change!
Reno eNVy
Anything is better than the accordions!
Went for a ride with the new twins... Rides nice still have a few things to work on.
What are the specs on them chargers; if you don't mind me asking?
Both inner tie rods, resealed extension housing to front diff, alignment, oil change, rear diff and transfer case service, tire rotation and fixed a leaking coolant hose. Hopefully its good to go for another 190k. LOL
New front bilsteins shocks, cabin air filter mod, 4x4 t case range switch, oil change, new lift pump, ordered 4.56 gears for the back..should be her by COB tomorrow..
If I like them I get the fronts.. Gear swap will Bump my driving rpm range up ~600rpms and allow me to utilize 6th gear. And allow me to use 5/6 gear at 65-70 vs 4/5 gears and take load off engine/transmission
If I like them I get the fronts.. Gear swap will Bump my driving rpm range up ~600rpms and allow me to utilize 6th gear. And allow me to use 5/6 gear at 65-70 vs 4/5 gears and take load off engine/transmission
01-10 trucks have same heat/AC box.. GM ran cabin filters from the factory for 01/02 stopped in after than... The boss for the filters are still there but not cut out.. GM came out with kit where you cut the hole open and it closes it..
Part number 22759208 lists for $31.00
http://www.dieselplace.com/forum/71...55-cabin-filter-install-2003-2010-trucks.html
Last edited:
Valley one is an s475 atmospheres are s472's all have TCT compressor wheels 87 turbines and 1.0 housings. The atmospheres are stainless v banded.
Add another thing to the list of parts I need! That's great! I'm always stuck behind big grain trucks on dirt roads.
I have a bunch of parts sitting on my desk and elsewhere that need fabed or installed. If I had the sump with me this morning I could have installed it. I ran out of diesel in BFE and it would of been a perfect time to install it on the side of the road.
Also the truck is reminding me that it is getting cold out and it wants a couple new injectors.
Also the truck is reminding me that it is getting cold out and it wants a couple new injectors.
