Scrapped 8" of snow off the hood, cranked her up and cruised to work. AF-ingmazing how much nicer it is to drive than the Fucus
"OFFICIAL" What did you do to your D-Max today?
- Thread starter Hot COCOAL
- Start date
Winter prep. 781,569
Changed tires from
To
Changed oil from 15w40 to half 5w 40. Greased
Air filter cover switched over to one with holes in it. Took filter out dropped it on the ground a few times and put back in.
Removed my mesh grill here:
And put on Billet
Changed tires from
To
Changed oil from 15w40 to half 5w 40. Greased
Air filter cover switched over to one with holes in it. Took filter out dropped it on the ground a few times and put back in.
Removed my mesh grill here:
And put on Billet
Grease oil change on my LMM,
Then played/measured with some 315/70/17 on 17*9 with 5" bs really needs 4-5" lift and 9" with 6" bs and 1-2" lift in the rear.. 6" will suck the top of the front tire even with the fender
Then played/measured with some 315/70/17 on 17*9 with 5" bs really needs 4-5" lift and 9" with 6" bs and 1-2" lift in the rear.. 6" will suck the top of the front tire even with the fender
Oil Came from the oil fill tube the cap was wedged up in the back from all the pressure. I have not torn the engine down but its most likely a cracked piston. She still runs but shes not happy!
I really like the 472 it spools a tad slower than the 468 but a lot more go on the big end! Its a little smokey but nothing bad at all.
Retrofitted my LB7 and paint matched the headlights and turn signals.
Too bad you didnt write DYI on this. Looks damn good!
Dude that's so tits.Retrofitted my LB7 and paint matched the headlights and turn signals.
Sent from my SAMSUNG-SM-G928A using Tapatalk
Looks almost in the same shape my truck is in. Lol
Good luck buddy.
Sent from my SAMSUNG-SM-G928A using Tapatalk
Good luck buddy.
Sent from my SAMSUNG-SM-G928A using Tapatalk
It has definitely been a pain in the ass.. But surprisingly everything has came apart pretty easy no broken bolts and minimal frustration. I am mainly terrified of the assembly stage, lol there are so many harnesses and 10mm bolts that go to nothing its mind blowing :roflmao: I figure that I have about 12hrs of work into it so far, from a driving truck to a short block :thumb: (With a few beer breaks of course) :rofl:
Dude that's so tits.
Sent from my SAMSUNG-SM-G928A using Tapatalk
I actually plan to, I still have a few adjustments to make to them so when im doing that will go ahead and take pictures and do a DIY write up.
Drove it in the snow. Got rear wheel well liners today and nerf bars. Hopefully I get new duraflaps soon so I can keep the shit off my truck
I would like to say thank you to Wyoming Highway Patrol. Witnessed a runner today, on I-80 East heading into Rick Springs. It was over within 20 miles. With no other drivers harmed.
Wyoming Highway Patrol Captures Driver After 120 MPH Chase - SweetwaterNOW
Wyoming Highway Patrol Captures Driver After 120 MPH Chase - SweetwaterNOW
What brand of wells? My friend got some for his just from Amazon but they seemed kinda chinsey in person
Sent from my iPhone using Tapatalk