looks pretty sweet. may have to get a triple gauge pod for this. if you could find a way to keep memory when the key gets shut off it would be killer. I'd pay extra for that.
hmmm ill have to look into that. It would require a lot of changes to the software code but I might be able to do it.
The only potential issue I see is that the EEPROM (the non-volatile 'storage' memory in the controller chip, the memory that doesnt get erased when power is shut off) in the controller chip has a limited number of write cycles before it wears out and is no good anymore.
Ill have to check the datasheet on the chip, but I think its somewhere in the thousands of write-cycles. Each time you turn off/start your truck it would 'use up' one of these write-cycles.
So say if you shut down/start up your truck 5 times a day, the DSP-5 switch MIGHT completely die after as little as ~1-2 years.