New clutches
- Thread starter Mike L.
- Start date
So far all the OEMs have dropped them because of failure. Single sided clutches are very thin ( .050-.065 ). This does not help heat dissapation. It spreads the load pretty well. They are said to be better in general.
Problem with the Alli is they have no lube slots and oil needs to get to them and lubricate them. This does not happen with the Alli.
What stall ml converter would be a good dd sledpuller . I will be pulling a gasser to the pull and both will be hookin to the sled . the truck should be 650hp to the rollers this year maybe better with a little luck .
what turbo ? if its stock turbo the "ML" would be a good choice , if its a larger turbo the "sled Puller 2300"( depending on turbo size of course) may be what I would go with, until more info is given but pretty much no way around it a phone to who your ordering from with a lot of info is needed to spec a converter 100% .
who is good to deal with for the ml converter . Can I get a name and number . I need to get figuring what I am going with cause my turbo showed up today . How does the ml converter compare to a suncoast . Thanks
ML Converter= Mike L.
Call Mike. 714-870-7300
I Had 3 different converters in my 08' two of them were Suncoast, I Liked the ML best out of the 3
so these for sale yet?? I'll be pulling my trans here soon and have another tore apart that needs C3s now.
Won't see them till the end of the year. I haven't had time to send my specs in yet. If you are in a hurry I suggest buying a kit that's out there. They will be fine if you get the right builder.
