Motor is coming out

[TROJAN366]

Fml

 

[derek06]

2x cp3 and bigger sticks

 

[dmaxbowtie]

What are your power goals steve?

 

[TROJAN366]

800 on fuel with the 2xcp3 and 72mm. I was really hoping for 625-650 on fuel yesterday though

 

[TROJAN366]

So I bought dual fuelers. Woooo

 

[Sledheadxp800r]

:woott:

 

[hondarider552]

So I bought dual fuelers. Woooo

I want them, I don't need them.






Fighting my inner self is hard :roflmao:

 

[TROJAN366]

I was planning on doing them over the winter but I couldn't handle being beat by a dodge on the dyno this weekend so I put my dirtbike on craigslist and told PPE to mail it lol.

 

[derek06]

Could have had it last winter... But no it was snowmobile season :happy2:

 

[TROJAN366]

Derek, snowmobiles are awesome. Although it doesn't do me much hood right now lol. Should be here tomorrow. Can't wait to get this thing on the truck!!!

 

[TROJAN366]

Installed the fox 2.0s finally. All 4 of my stockers were junk. Ride is definitely improved. A little stiffer but no bounce so it is a step on the right direction. Not sure how these will launch in 4wd but I would have to imagine that will be better too.

2xCP3 goes on next week. Really excited. Truck is finally starting to come together.

 

[juddski88]

I would try spring clamps vs. Those bars when you go to the track, I'll bet money you 60ft better with clamps

 

[TROJAN366]

I ran clamps along with the bars last time. In hindsight caltracs probably would have been a better choice but I'm making due. You think i should take them off and just run clamps at the track?

 

[derek06]

Yes... Clamp springs and call it a day 1/10!!! :roflmao:

 

[TROJAN366]

I'm talking to a kid right now about 30x12 M/T sportsman SRs mounted on 18s. I think those combined with nitrous the second I let off the brake should work nicely lol

 

[juddski88]

I wouldn't waste your money on tires until you get the suspension working properly. I would take the bars off because they cause the front end to lift due to their angle on your truck.

 

[TROJAN366]

Maybe next time I head to the track I'll bring the tools and try both ways. But the tires are a steal. So I might still get them. Kid said he cut 1.56-1.59 60' in a crew cab with them

 

[juddski88]

I have no doubt he did, but you can cut high 1.6 low 1.7 with what you have. that's all

 

[TROJAN366]

Dual Fuelers are going on Tuesday along with an Allison Deep pan, fresh filter and some new Dex 3. Can't wait to see how this thing runs with some rail pressure!

 

[DieselmafiaLLY]

I wouldn't waste your money on tires until you get the suspension working properly. I would take the bars off because they cause the front end to lift due to their angle on your truck.

how should they be angled then?