Soo re installing my injector cups and I have one that refuses to seat.. Its very close but not flush yet. I've Tried pressing it in w the injector retaining bolt, however at the torque spec, (37 ftlbs) even the holder isnt flush and I don't want to force it more with it being an aluminum head.. The question now is wtf do I do.. I guess I need to pull it and get a new cup however I have no puller and It will be tom before I can get one. By then the thread locker will be cured. Its the #7 injector cup. I'm not sure if its just not pressing straight or what. The accumulator is in the way a little to get a 100% straight hit, but I managed to make it work on the #8 cup with the steering shaft in the way.. Any advice? I'm at my whits ends here...