So anyone gonna tell how to do this $7.99 lock up switch!?
So anyone gonna tell how to do this $7.99 lock up switch!?
So anyone gonna tell how to do this $7.99 lock up switch!?
Yeah I think it's a blue wire you ground out. I built one on my truck about 4 years ago. Simple lock up with no pwm ramp up. Harsh lock
Toggle switch to ground. Your tcc solenoid will burn up pretty quick tho. Bens box sends a PWM signal to the tcc solenoid just like the tcm does...no chance of it burning up.
You wont if you use it as it was intended for.... Sled pulling or drag strip and no more than that.Hmm...... What about the dhd box? Am I going to burn up the solenoid by using it too much?
You wont if you use it as it was intended for.... Sled pulling or drag strip and no more than that.
So how are you leaving the line? With it locked, or flip it right after launch?
If you lock it while you're still standing still, you'll either stall the engine or the truck will suddenly jolt forward as if you just side-stepped the clutch in a manual-trans vehicle.
That's what I was thinking, so how does yours lock? As soon as soon as it shows 100% TPS?
That's what I was thinking, so how does yours lock? As soon as soon as it shows 100% TPS?
yes because its the same principal... no pwm, straight dc voltage to the solenoid.
Had I know this before purchasing the dhd box I probably would have passed and went with Bens box. There should really be a disclaimer on the website stating that extended use could burn up the solenoid. I'm not too happy hearing this.
Had I know this before purchasing the dhd box I probably would have passed and went with Bens box. There should really be a disclaimer on the website stating that extended use could burn up the solenoid. I'm not too happy hearing this.