Search results

  1. G

    Lb7 injector nightmare

    lb7 Did you put in new injector cups
  2. G

    2001 Duramax Power steering

    p/s sounds like a hydroboost issue to me causing high pressure. i had several where the check valve in the hydroboost failed and caused this. not sure if you have access to pressure guages but it may help checking pressures?!
  3. G

    injectors

    dont go as cheap as possible. i have an 02 apart now for the third time in 3 weeks because the customer keeps getting injectors from dcp on ebay. what a joke!
  4. G

    P0751, P0761, P0877, P0701, P0218, P0711 need some help

    trans range switch Ive had several that needed trans range switches
  5. G

    HELP please! Brake light and chimes on, but...

    brakes Does it have a brake fluid level sensor in the master cylinder?
  6. G

    05 GMC 4500 TCC Issues

    Tcc i agree. im not one to do the parts shotgun approach. maybe the tcc solenoid temperatur vs resistance is wacking out under load or its going completely open??? However it does come down to a rebuild and converter thats fine too id just like to pinpooint exactly the issue.
  7. G

    05 GMC 4500 TCC Issues

    Im working on an 05 GMC 4500. It sets the following codes when pulling a trailer with a skidloader on. P0741 TCC circuit performance or stuck off p2764 TCC pressure control solenoid control circuit low p2761 TCC pressure control solenoid circuitl open Ive checked the circuits from the TCM to...
  8. G

    Alternator Maybe?

    alternator load test the alternator and see how many amps it putting out. not sure what autozone used or did.
  9. G

    Need some help.

    p0700 you probably wouldnt have to go to a dedicated trans shop. most shops should have a scanner to pull the codes, command fuel pressure, watch balance rates etc. if you were closer id check it with mine.
  10. G

    Need some help.

    p0700 p0700 indicates there are trans faults stored in the TCM. possible trans issue? most likely theres more codes than what your scan tool lets u see
  11. G

    Rear end making clicking noise

    rear end where are you located dirtmax?
  12. G

    Rear end making clicking noise

    rear end One other thing i have seen on rare occasions is the axle bolts loose. you may just want to take a quick check. ive had two trucks that the axle bolts worked themselves loose and caused problems.
  13. G

    Rear end making clicking noise

    rear diff i had an 05 lly. It did the same exact thing. GT4 3.73 gear and G80 for the gov lock. The gov lock gernaded in mine i ended up putting a whole new carrier in it and bearings. i highly doubt a fluid change will solve anything!
  14. G

    lb7 heads???

    anyone got any good or upgraded lb7 heads for sale? or valve springs? got my bottom end built and assembled. i gave my heads to a guy last october and he has done absolutley nothing to them. let me know if you have anything. thanks
  15. G

    98' HVAC controls toasted

    i dont remember off the top of my head i have it all wrote down in my toolbox
  16. G

    98' HVAC controls toasted

    the late 90's had some blower motor resistor problems. pay close attention to the ground wire in the blower motor resistor connector it may be melted.may sound stupid but you may want to check your amp draw on the blower motor. ive chased that before
  17. G

    LLY: Time to build the motor

    Repositioning the harmonic balancer is not how you balance a bottom end or rotating assy. the stock harmonic balancer is zero balanced and is meant to go on one way. If you have an aftermarket damper "yes" you can adjust more but it even comes zero balanced.
  18. G

    LLY: Time to build the motor

    i seen you mentioned balancing your crank. id be interested to know how there balancing yours? how far out it is? and did they purchase or make the bob weights to balance it correctly?
  19. G

    Air leak sound at high RPM

    Take your map sensor out and smoke test system