Search results

Search the forum Search Articles
  1. hondarider552

    Going for tens in the zf. (Mission Accomplished!!!)

    Cromoly is roughly double the cost, so if it was a 60$ difference, that's some expensive ass DOM :D
  2. hondarider552

    Will 60' improve with 3.42s

    Whats your end RPM through the traps? Need to see where you make peak power and then compare it to RPM and see where your setup starts to run past its peak. I want to say 3.73 to 3.42 lowered top gear RPM by about 300rpm.
  3. hondarider552

    Will 60' improve with 3.42s

    Cant say. changed turbo setups at the same time. went from 9.25 to 9.04 and 148-153
  4. hondarider552

    Will 60' improve with 3.42s

    With 1600hp at the ground we haven't seen any change in 60' or 330' running 9.00's and 3.42's. 60 remains the same 1.41-1.45
  5. hondarider552

    Going for tens in the zf. (Mission Accomplished!!!)

    Good deal on the 10 point. I went bare minimum on my LB7 and regretted it. I went full 7.50 cert on my half ton.
  6. hondarider552

    Got fuel?

    Nate was this an LLY?
  7. hondarider552

    What did you do at work today?

    That's above your pay grade
  8. hondarider552

    Going for tens in the zf. (Mission Accomplished!!!)

    Just don't launch like you did on slicks or you will be replacing parts
  9. hondarider552

    Going for tens in the zf. (Mission Accomplished!!!)

    When you buy a pin on hood let me know what that weighs too please :roflmao::D
  10. hondarider552

    Going for tens in the zf. (Mission Accomplished!!!)

    Less. My GTS fiberglass doors for my half ton are 5 lbs each, 7 with the factory brackets for door hinges.
  11. hondarider552

    CCSB 4x4 Wheelie Bars Needed.

    Looks like it will hook better in 2wd :D
  12. hondarider552

    Half ton thread

    Haha yep. Rather have it, and not need it than need it and not have it.
  13. hondarider552

    Half ton thread

    Parachute for 12.50 when the brakes fail :D:roflmao:
  14. hondarider552

    Half ton thread

    You and me both. Been almost 2 years since I got a stupid thought in my head to try the turbo LS world.
  15. hondarider552

    Half ton thread

    Been a long 8 months. Between some setbacks here and there, this is the longest ive owned a truck without driving it. Funny car cage is in and fully welded, dash bar is in, back supports, just needs the X bars on the doors and were done. Rear built axle is in, 3.42 gears are in, drag...
  16. hondarider552

    Tough engine

    While racing me, I helped break your engine and I didn't even know it haha
  17. hondarider552

    Tough engine

    I killed my stock engine LB7 with paper license plates on it still. :D:spit:
  18. hondarider552

    LML Mega cab

    A bit, would be a compliment, so, thank you. I sold all my duramax' and drive a gay 06 Cummins, so I guess it comes with the truck :D:hug:
  19. hondarider552

    LML Mega cab

    Guess we can let it slide :D Yeah, I do 12oz curls.
  20. hondarider552

    LML Mega cab

    This is a performance board, not diesel brothers. :thumb::D
Top Bottom