Search results

Search the forum Search Articles
  1. skintback

    Crankshaft issues

    Good info When talking about balancing a motor what would you need to tell your machinist? Have it done to zero or i here some say to over do it for higher rpm's but by how much or what to what at how many rpm's? Say i want to run at 4500rpm's so i should have it balanced to 4500? What about...
  2. skintback

    S468 v.s. S472

    I'd go with the 68 and twin it after the built motor :D
  3. skintback

    Hit the 1/4 mile

    Hows that pump working with those 60 overs or are you air limited now nice runs
  4. skintback

    New Clutch Problems

    Is it a south bend? I know there DD are a little noise
  5. skintback

    Congrats Trrent goes 146 mph

    Nice job :thumb: I seen the GAW dodge CR run two weeks ago down here in FL 10.62 on fuel and 9.39 at 148 with a 1.50 60 on the good stuff your times go right there with his congrats
  6. skintback

    LBZ rails on LLY?

    Is there any benefit to put lbz rails on a lly? I know that ppe sales a modded lly driver side rail but i have a set of lbz rails and lines not sure if it will bolt up but may have to give it a try
  7. skintback

    Grenaded CP3

    I have replaced one that looked just like on a 02 still ran but fuel was running out everywhere
  8. skintback

    Help: LB7 new head studs and cups but still have water leak

    So to get by with one time you should tq them to 150 :spit:
  9. skintback

    Help: LB7 new head studs and cups but still have water leak

    I don't think cycling the studs 3-4 times is going to make it or break it. How snug was the fit when you installed the cups did you tap them down with a socket and hammer first and then install the injector?
  10. skintback

    LB7: oil is black in one day is this bad?

    Sounds normal to me
  11. skintback

    Anyone interested in a meet in NorthEast FL???

    I'm about 5hrs or so south of you
  12. skintback

    For any of you guys with Dodge Truck buddies

    WOW that is cool wish they had that when i bout my V1
  13. skintback

    Regulator questions

    What is the difference in the FPR's between all? I know what the sleeve's look like and that the lb7's are straight and lly/lbz/lmm have a 90* do they all run on the same volts/current tuning? Why does a modded reg not effect a CR dodge at idle or other speeds like it does a dmax? Is the reg...
  14. skintback

    Fuel pressure regulator/Surginf idle

    I'm thinking the reg
  15. skintback

    Extended cranking now no start

    May be the cp3 getting weak Take the filter housing apart one time i had friend get some trash in there and it was causing the plungers to stick open letting the fuel back to the tank
  16. skintback

    Stock TC and Trans 12.93

    LBZ reg cab 4x4 no doubt 12's with a jr for a little while :D Nice runs anyway :thumb:
  17. skintback

    Labor rates!

    Down here the old ford dealer was 102.00hr last time i checked not sure what the chevy dealer is but i'm sure it's not to far from that :eek: I would say 500 is fair
  18. skintback

    Fuel lab pump installed

    Nice :cool2: How loud is it? I've been thinking about try the 200gph@20psi pump
  19. skintback

    Rail pressure with 2 micron filter....

    When i installed the AD i did away with the stock setup so i can't say what mine did for psi +/- but before that i ran a edelbrock 1792 with stock filter at 10-17 psi with no problems. What is the filter # on the cat 2 micron and does it separate water? I'm looking to ditch my AD but i'v...
  20. skintback

    11.97@113mph

    Nice job
Top Bottom