Hey fellas, I have an LB7 CP3 about 80% torn down out in my shop. How the heck do you get the shaft/rotor and pumping elements out I have this strange and bad feeling that all the pump elements have to be depressed to get the shaft out?
Its used of course and may or might not be good, so far i see nothing too out of place, one of the pump element caps and inlet valve was kinda dirty. I'd like to tear it completly apart and inspect and clean it out real good and see if i can apply some ideas ive had.
So if any of ya can help, i'd sure appriciate it! And if any one knows where i can get parts if i need them!
Thanks in Advance, Chris!:hug:
Its used of course and may or might not be good, so far i see nothing too out of place, one of the pump element caps and inlet valve was kinda dirty. I'd like to tear it completly apart and inspect and clean it out real good and see if i can apply some ideas ive had.
So if any of ya can help, i'd sure appriciate it! And if any one knows where i can get parts if i need them!
Thanks in Advance, Chris!:hug: