Search results
-
F
Compression test - dead piston or head gasket issue?
Just did a compression test on my LB7. It was done cold and all look good besides #7. Think it is head gasket or piston/rings? I was about to get some injectors ordered but now I am not sure what I am going to do. See the mist/smoke while cranking, is that oil fume from crankcase pressure...- freeloader700
- Thread
- Replies: 11
- Forum: LB7
-
F
New driver door seal still leaks in
I replaced the door seal for the driver front and I am still getting a leak. In the picture you can see where its wet on the seal. That is where it is seeping in from the door. I tried adjusting the seal a bit but no luck is stopping it. I know the leak is not coming from anywhere else, all the...- freeloader700
- Thread
- Replies: 14
- Forum: Appearance & Detailing
-
F
Rear corner drip molding leaking
This little strip of trim or drip molding is causing a leak. How is this installed? Is it just glued/sealed into place? Can I just run a bead of silicone under it and squish it back down? Sent from my SM-G965U using Tapatalk- freeloader700
- Thread
- Replies: 3
- Forum: Appearance & Detailing