Recent content by freeloader700

  1. F

    Compression test - dead piston or head gasket issue?

    Put some oil into the glow plug hole and no ZERO compression. Verified that the gauge is still working with another cylinder. Sent from my SM-G965U using Tapatalk
  2. F

    Compression test - dead piston or head gasket issue?

    White smoke a injector knock. Low power, all the typical injector symptoms while not having the head gasket symptoms. So for peace of mind I wanted to rule out the gasket before ordering the injectors and here we are now. Sent from my SM-G965U using Tapatalk
  3. F

    Compression test - dead piston or head gasket issue?

    I did not remove bail connections on the passenger side however I disconnected both large connectors on top of the motor feeding those circuits. Plus I removed fuses #1 EDU & #3 Fuel HT. If it were fuel coming out, wouldn't that effect all of the injectors? This was only happening on #7. I will...
  4. F

    Compression test - dead piston or head gasket issue?

    Blow by is very minimal. Upside cap stays on just fine. Upper radiator hose does not stay hard after cool down. Coolant system does not seem to be pressurized. There does not appear to be any water nor fuel in the oil. I think I have checked all my bases. I got this a year ago and finally in a...
  5. F

    Compression test - dead piston or head gasket issue?

    Just did a compression test on my LB7. It was done cold and all look good besides #7. Think it is head gasket or piston/rings? I was about to get some injectors ordered but now I am not sure what I am going to do. See the mist/smoke while cranking, is that oil fume from crankcase pressure...
  6. F

    New driver door seal still leaks in

    Do you happen to have a photo of what you did? What size sheet did you cut it to, half the width of the door? Sent from my SM-G965U using Tapatalk
  7. F

    New driver door seal still leaks in

    Weep holes are clear. I made sure using some string trimmer line. Is that really a normal amount of water that enters the door? Sent from my SM-G965U using Tapatalk
  8. F

    New driver door seal still leaks in

    Tried the core seal and bending the flange and that helped but did not fix it. So I took the door panel off and man....water is gushing into the door from what appears the window track? How would this much water be coming in? Source: https://youtu.be/mTYrfEhxo2Y?feature=shared Sent from my...
  9. F

    New driver door seal still leaks in

    Never heard of it. I will certainly give it a try Sent from my SM-G965U using Tapatalk
  10. F

    New driver door seal still leaks in

    Weep holes are clear Sent from my SM-G965U using Tapatalk
  11. F

    New driver door seal still leaks in

    I replaced the door seal for the driver front and I am still getting a leak. In the picture you can see where its wet on the seal. That is where it is seeping in from the door. I tried adjusting the seal a bit but no luck is stopping it. I know the leak is not coming from anywhere else, all the...
  12. F

    Rear corner drip molding leaking

    Okay cool I will give it a shot. Thanks Sent from my SM-G965U using Tapatalk
  13. F

    Rear corner drip molding leaking

    This little strip of trim or drip molding is causing a leak. How is this installed? Is it just glued/sealed into place? Can I just run a bead of silicone under it and squish it back down? Sent from my SM-G965U using Tapatalk
See more
Top Bottom