LB7: Truck feels fast for a short time......
- Thread starter JustinD
- Start date
The passenger side batt sweats from the heat of the turbo get an ac delco or an interstate batt and it wont do that.I even tried 1 of those stupid expensive optima batts and that s o b sweats also.Hope you have the problem fixxed now my friend :thumb:
Here are a couple logs from last night, anyone take a look and see if it looks ok? It doesn't seem to be limiting main injection timing or main injection fuel flow rate anymore but it does seem like its good going real easy and going real hard but when I roll into it I feel like it isn't what it should be?
Thanks guys!
Thanks guys!
It should stay put until you change elevation... It may vary a little, but not like that... It may or may not be 14.7..... I live at 6700ft and mine reads 11.43.... But fluctuating all over isn't right...
Should I change it? I remember this happen about a year ago, I swapped it with a known good one and it was fine til now?
Just looked at a log from when it was limiting fuel, about 2 months ago, it stays at 14.6 in that log never moves. 
Ok, is it just a bad sensor? This is the second time I have seen this in my truck. Is it common for them to go bad or act up?
Only thing I see now is B0805 is referencing 6.1-11.9 cells, and when I use an older log where my baro is 14.6 it references the 14.2 cell which is 1.
This my B0805 with my sensor reading all over the place.
And this an old log when my baro was staying at 14.6
Can I just make these values all 1?
This my B0805 with my sensor reading all over the place.
And this an old log when my baro was staying at 14.6
Can I just make these values all 1?
No turns out I chose the wrong pid it reads ok now, I think my trans is hurt and doing this?? Seems like its ok until it fully adapts? Shifts funny too like it hesitates to make the shift. Hoping it's not a total loss I just had it re done about 3 years ago.
---
I am here: http://tapatalk.com/map.php?ixlncf
---
I am here: http://tapatalk.com/map.php?ixlncf