I just ordered a stage 2 snow performance water Meth kit with 7 gal tank.. any tips on what psi to start spraying also I will only use it for truck pulling mostly and probably run only 20% Meth thanks
stage 2 water meth tips??
- Thread starter bluecollar
- Start date
It lowers egt and adds power with the more Meth u add and mostly safe when injected right and only so much Meth most say 50/50 is ok..there's more to it than that but that's gives an idea
Posted via Mobile Device
Posted via Mobile Device
super diesel
<<<< Under Pressure
I use to set mine up for about 18psi with a stock charger (24-26psi with something bigger). This was wide open stage though, not progressive. Windshield washer fluid is good but anything more like up to 50/50 you will get a lot of noise that doesn't sound good. It works but not my cup of tea. I only use straight water in mine anymore (you only get about 1/3 the cooling and power gain though with just water, but no noise).
Set psi low for mileage, set it high for power. Like said before i use to set mine at 18-20psi cause i wanted more power then anything. I set top setting about 38psi or so so i didnt ever max it out. U will hear it to, just like stated also. I have since put twins on and do not use it. Will be selling it if someone is interested. Only a year old, works perfect, have all parts and directions.
The more meth the less coolin effect u get from it. I went 30%meth to water. Theres no way i could see 100hp on these kits. I agree with pat. 40-60 depending on set up.
I ran a 50/50 mix and it didn't do jack shit for me. I think it made my truck run hotter if anything.
I'm interested in it. Can u set it for economy and power or jut one or the other. I drive 300 miles to wrk do always lookin for something to boost mpg. And does it inject all the time? And it doesn't hurt your engine?
Thanks superdiesel and yes on duramax forum there are Ppl saying dynoed stock then ran 50/50 and gained 100hp take it as u will lol
Posted via Mobile Device
Posted via Mobile Device
Here's the deal the kit I'm getting has been used twice then sold the truck I paid 225 for it and the 7 gal tank that it has cost 150 so y not lol I will give feed back as soon as it gets here and put on
Posted via Mobile Device
Posted via Mobile Device
that explains everything.
I can almost guarantee, that unless you spend a lot of time on trial and error with your WM setup, the results wont be anywhere near what you are expecting.
Tell me about it.
OP, also research some of the bad things too much water/meth can cause.
So u guys that are bagging on it I won't see 20 to 40hp?? If any of u want info on it go to duramaxforum.com their is a sticky with 13 pages about.. I just like this site more
Posted via Mobile Device
Posted via Mobile Device
And it will be on the dyno on the 12th so I will give an idea what 20 to 30% Meth with do and yes 2 much Meth is bad. But so is big turbos on stock rods and alot of ppl do that
Posted via Mobile Device
Posted via Mobile Device
And no I'm not expecting alot 40hp and cooler egts that's about like putting a bigger Turbo on stock fuel.. and if it rattles from what I understand less Meth or inject at higher boost
Posted via Mobile Device
Posted via Mobile Device