LBZ: S480 truck / big singles

Yngdmax92

Active member
Sep 26, 2013
962
44
28
Just thought I'd share my opinion on a big single truck since I have never drove one until last night.

Friend just bought a lbz with 60 overs, bullseye s480/hsp kit and big Dipper built trans with moonshine tunes.

Don't get me wrong the truck felt strong, pulled hard and was a blast to drive. But, I am sure glad I have never taken that route as the truck was not fun to drive unless you are wide open or really turning some rpms. Truck will blow the tires free at 50mph which is bad to the bone, but the trans needs a serious tune or else you'd have to drive the thing with the tap shifter all day. Smoke control is tuff, your really need to be careful lugging up grades and taking off was iffy too. Cruising down the road if the converter locked in 6 the gear it was a dog. The converter seems really really tight for the 480 too, brakes mashed to the floor it can only build 11psi of boost before it starts to push through them.


Defiantly sticking with a upgraded vgt vs going big single, unless you don't use the truck for towing and truck stuff. I don't see the point of them. But , my smile was ear to while running it wide open and the sound was like no other!!

Sent from my Pixel 2 using Tapatalk
 

minerigger

Active member
Dec 24, 2013
2,660
1
38
Casper, WY
I can't imagine something that big, I had A s366/74 .91 and at 5300 ft I want to burn my truck to the ground. I hated it beyond measure...with rpms it was a blast but everyday driving I had to use the tapshifter. I'm in your boat, modded vgt all day

Sent from my SM-G930V using Tapatalk
 

SickLL7Crenshaw

Billy The Kid
Mar 10, 2013
1,088
34
48
31
Mexico
I can't imagine something that big, I had A s366/74 .91 and at 5300 ft I want to burn my truck to the ground. I hated it beyond measure...with rpms it was a blast but everyday driving I had to use the tapshifter. I'm in your boat, modded vgt all day

Sent from my SM-G930V using Tapatalk

I’m surprised you hated that fixed vane that much Brock. With that turbo you shouldnt have had to use the tap shifter like you did even at 7000ft IMO.
 

Chevy1925

don't know sh!t about IFS
Staff member
Oct 21, 2009
21,681
5,833
113
Phoenix Az
I’m surprised you hated that fixed vane that much Brock. With that turbo you shouldnt have had to use the tap shifter like you did even at 7000ft IMO.



On stock part throttle shift points and converter locked, I can see it. Gunna be laggy unless the converter is unlocked or shift points keep you over 1800-1900rpm
 

SickLL7Crenshaw

Billy The Kid
Mar 10, 2013
1,088
34
48
31
Mexico
On stock part throttle shift points and converter locked, I can see it. Gunna be laggy unless the converter is unlocked or shift points keep you over 1800-1900rpm

I honestly don’t. I could with a 1.0 or 1.10 housing though. Part throttle shifts do make it way nicer with those housings but with a 74 .91 it shouldnt be THAT bad. Towing 16k with a 66/74 .91 up to 11,530ft (slumgullion pass) I didn’t have any issues nor hated it. Did very well IMO. 2300 stall/stock injectors. Daily driving was very nice. The 69 however does like to be above 1900rpm but still does fine when towing 12k
or lighter.
 

minerigger

Active member
Dec 24, 2013
2,660
1
38
Casper, WY
I dunno, I think it needed some live tuning. I'd try it again but I don't have the time to drive it anymore

Sent from my SM-G930V using Tapatalk
 

Chevy1925

don't know sh!t about IFS
Staff member
Oct 21, 2009
21,681
5,833
113
Phoenix Az
I honestly don’t. I could with a 1.0 or 1.10 housing though. Part throttle shifts do make it way nicer with those housings but with a 74 .91 it shouldnt be THAT bad. Towing 16k with a 66/74 .91 up to 11,530ft (slumgullion pass) I didn’t have any issues nor hated it. Did very well IMO. 2300 stall/stock injectors. Daily driving was very nice. The 69 however does like to be above 1900rpm but still does fine when towing 12k
or lighter.



All the trucks I’ve got info from as well as drove, lag tested at 1800rpm or more before the s366 would come on. Sxe will probably be better. First two I have was one in a triple kit (366 with 2 362 under it) and other was Brian’s old white whale with 366 over 480. There is also my buddy Sean with 366 over billet 480 and race cover and still the same.
 

minerigger

Active member
Dec 24, 2013
2,660
1
38
Casper, WY
My 366 was a blast above 1900-2000 But an absolute fkin pig below that. I do think fuel would've helped obviously I think there was always something missing in the tuning. But alas I'm not a tuner and not one to even begin to guess where or what to start looking at

Sent from my SM-G930V using Tapatalk
 
Last edited:

minerigger

Active member
Dec 24, 2013
2,660
1
38
Casper, WY
It sucked i dont/didnt have anyone close to look at it as I think it would've helped. But I'm more than happy with the stg2r. I would like to take it back and have mark dyno tune it and maybe add some goodies

Sent from my SM-G930V using Tapatalk
 

SickLL7Crenshaw

Billy The Kid
Mar 10, 2013
1,088
34
48
31
Mexico
It sucked i dont/didnt have anyone close to look at it as I think it would've helped. But I'm more than happy with the stg2r. I would like to take it back and have mark dyno tune it and maybe add some goodies

Sent from my SM-G930V using Tapatalk

A little extra fuel does indeed help any fixed vane light faster. Especially up in the clouds like we’re used too.
 

Ne-max

I like turtles
Nov 15, 2011
3,361
64
48
Lincoln, Ne
Big singles keep engines alive. But also it's a must to have the right pieces to the puzzle. One wrong piece you will have a hot and laggy turd. Lighter the truck the better also.
 

minerigger

Active member
Dec 24, 2013
2,660
1
38
Casper, WY
6800lbs is all the lighter she was getting. Had a trans from Evan, along with a 1058 and Kory tuned it. The rest is all stuff we all have and it didn't have any boost or exhaust leaks...i know where I was leaning but I'm just speculating

Sent from my SM-G930V using Tapatalk
 

Yngdmax92

Active member
Sep 26, 2013
962
44
28
I don't even want to drive a properly set up one, the big single is not for me. Unless, it was a strict play truck which on my salary, a daily is about all I can afford lol

Sent from my Pixel 2 using Tapatalk
 

SickLL7Crenshaw

Billy The Kid
Mar 10, 2013
1,088
34
48
31
Mexico
I’ve never cared for the 1058 in any truck honesly. There are far more superior options out there now. When I think 1058, I think no coupling, outdated, tighter then advertised converter. A lot of people still run the 1058 with modded VGTs and like it. If they say that they do like it, they have clearly never tried, for example Evans 1078 in the place of it. It’s night and day.
 

minerigger

Active member
Dec 24, 2013
2,660
1
38
Casper, WY
If I keep the truck that will be the next mod...swapping the 1058 with his converter

Sent from my SM-G930V using Tapatalk