LB7: priming built motor

[02greysixer]

Well got it chugging but act is 26k while cranking.Somtin not koshure

Check bulk connector pins. Sounds like it isn't seeing the rail pressure sensor and has defaulted to max r.p. reading.

 

[CaptPhil]

Or your fpr is not plugged in.

 

[Bustedknuckles]

Or plugged in upside down. Saw that on a guys truck awhile back.

 

[LBZ]

Or your fpr is not plugged in.

Or stuck.

 

[NC-smokinlmm]

Or your fpr is not plugged in.

X2

 

[malibu795]

I never primed mine, I just unhooked bale connectors so it wouldn't start and hit the starter for about 10 seconds. hooked bale connectors back up and fired it up. With the amount of assembly lube they use it's not really going to hurt the motor, plus my first break in oil was 5-30.

I do similar thing

 

[dirtydmax]

frv is plugged in and also swapped one out to make sure.Time to start looking for a busted wire.

 

[CaptPhil]

Check the rail pressure sensor also.

 

[dirtydmax]

Check the rail pressure sensor also.

I was wondering about that but didn't know if it would raise the pressure.I have a lot of sensors gone and maybe its just freakin out!

 

[dirtydmax]

Also I am getting 3.5-4.5 v at crank to the reg.

 

[CaptPhil]

It will, if you unplug the rail sensor it will max out rail.

 

[CaptPhil]

Also I am getting 3.5-4.5 v at crank to the reg.

What voltage when it is running?

 

[dirtydmax]

What voltage when it is running?

Good question,I havnt got to the running part yet.

 

[dirtydmax]

Will removing the fuel temp sensor cause a high rail?Thanks for the help captphil.

 

[Huffy67]

I don't think the temp sensor would cause a problem

 

[dirtydmax]

I am starting to wonder if I am 180 out on the valves

 

[Ne-max]

Made this today. Sprayer cost 9.99 at the Home depot. The fitting cost 8.00 at Parker store. Screws right into my oil feed line on my valley s400. Fitting part number was 10656-6-4. (I ended up having them make me a long feed line also since mine was just a tad short) Worked like a champ. Put a gallon of oil in and pumped it up. It pumped it out slowly while I worked on other stuff. No mess.

 

[dirtydmax]

:thumb:great idea!