Ppe dual fueler

[whitey]

Does anyone know if ppe has changed the high pressure fuel line from the cp3 to the rail?

 

[Burn Down]

It's a 2 piece unit with a high pressure relief in it now.

 

[whitey]

I kind of figured that... I've been fighting this leak since it was new. They should offer a straight through line for racing application's that deletes the fuel block and all of that BS. Found a high pressure line guy that can make the line.

 

[duramaxzak]

Could try calling Dan from PPE to see if they have a fix for it!

Dan Grant 714-985-4825 ext 115

 

[moparkxracer]

Exergy makes them as well. I'm feeding the cp3 in the stock location to the passenger side rail and the cp3 in the dual location feeds the driver side rail.

 

[Chevy1925]

Exergy makes them as well. I'm feeding the cp3 in the stock location to the passenger side rail and the cp3 in the dual location feeds the driver side rail.

my LLY setup is the same way accept i just bought the flexable HP line from industrial injection and used it.

 

[whitey]

Do u have pics of it done that way? Have enough Xtra parts to do it.

 

[whitey]

What is the difference between the lly rails and the Lbz rails? Could I run two passenger side rails?

 

[whitey]

Would it be possible to run my lift pump straight to the valley cp3?

 

[moparkxracer]

I'm running dual sumps, to dual airdog 200's, to a distribution block to make sure the pressure to both cp3's is even. I have a one way valve on each line after the lift pump. Then run one line straight to each cp3 with the hose that come with the airdog I think it's -10 an line.

 

[moparkxracer]

In this pic you can see the high pressure line from the back of the cp3. Please excuse the wiring mess, working on cleaning that up.

 

[TROJAN366]

In this pic you can see the high pressure line from the back of the cp3. Please excuse the wiring mess, working on cleaning that up.

"the wiring mess" seems to be cleaner than 99% of the trucks on the page.

 

[moparkxracer]

I appreciate that, it bothers me. Hope to have all the extra stuff out of the harness soon. Just slow going

 

[Chevy1925]

"the wiring mess" seems to be cleaner than 99% of the trucks on the page.

damn steve...

 

[whitey]

Nothing that crazy... Just wondering about the supply line over to the fuel filter housing and then to the cp3. Wanting to get rid of all that BS, and go right to the cp3.

 

[moparkxracer]

You can, they also have a fitting to got to 3/8 hose into the cp3.

 

[whitey]

Is half inch fittings possible or needed. If so I would need one for the lift pump also.

 

[moparkxracer]

Not needed, I don't have any of the oem hard lines anymore. Did it that way to clean it up. I'm not your average setup.

 

[whitey]

Thanks!

 

[whitey]

I got my new 1 piece line back and installed, and went for a drive. And when I got back, I still could smell fuel. So I pulled out my mirror, and with the truck idling I looked at the rail, and there is a steady drip coming out on the bottom side of the fitting. The rp at idle is around 7 k. Any help would be great. Thanks
..