P0847 p0700 code

M

marc75

Member
Apr 22, 2009
111
0
16
Trans just built and change pressure switch still get these code p0847 and p0700 . When i put the truck in reverse or drive it s like the converter was locked i have to put my foot hard on brake and the engine shut down need help please btw it's a 2002 5 speed
 
Last edited:
M

marc75

Member
Apr 22, 2009
111
0
16
ok changed pressure switch and selenoid D all clutches the only thing left to do is intern wiring but a bad converter can do this problem ?? because when i put it on drive or reverse i have to put the pedal brake on the floor and the motor shut down
 
Mike L.

Mike L.

Got Sheep?
Staff member
Vendor/Sponsor
Aug 12, 2006
15,681
232
63
Fullerton CA
If you installed a Transgo converter flow valve, there is a good possability that the restricter plug ( the one you press in ) fell out and the converter clutch is being fed full time.
 
Mike L.

Mike L.

Got Sheep?
Staff member
Vendor/Sponsor
Aug 12, 2006
15,681
232
63
Fullerton CA
Make sure the shaft is not moving out of the pump stator support. Also make sure the same shaft is alingned properly. They are know for twisting. Compare it to a know good shaft.
 
Trotorx2

Trotorx2

Member
Sep 21, 2006
699
0
16
71
Beaumont, Texas
I feel for you...I wish I could help. Hopefully MikeL or someone will see this and help you out.

I see he did. Good luck hope you figure it out.
 
M

marc75

Member
Apr 22, 2009
111
0
16
Any chance that can be the bodyvalve ??? I can swap it before pull out the trans or i loose my time ??
 
M

marc75

Member
Apr 22, 2009
111
0
16
forgot to tell you it have a co-pilot on it can be the problem ?? or it's only for the pressure
 
You must log in or register to reply here.
Top Bottom