"OFFICIAL" What did you do to your D-Max today?
- Thread starter Hot COCOAL
- Start date
Nice Mike!Went down to see Mike L. to have him install one of his coolers. Man these are beautiful! While I was there picked up a couple spin-on filters and a couple stickers.
Sent from my VS988 using Tapatalk
I’m not allowed in the parts room, those filters always walk out with me 
Brother has been out of town all week and truck was down from a bad tcm. Stopped by my parents where he left it and put a new TCM in the LMM. Got her back shifting nice again. (Thanks again @mikel ). Years ago, I tuned it just to get rid of the p0101 code he’d get from the s&b intake. It got 35s and a lift since so I changed the tire size for the speedo to match and then did an OG 20/20 tune in her to pep her up some. He’s extremely happy and loves how it drives now. Still on factory emission system and I’m having him monitor dpf regens and soot loads to see how the tune works with it.
Took it on my first long drive since doing HGs and 100overs. Went to Louisiana to help out with some hurricane Laura relief. 17Mpg Which is about where I was on stock injectors. That bummed me out a little bit I was hoping for a little better. Realize I must have not gotten the V band on the downpipe on correctly and had a massive exhaust leak. I’m getting ready go back to Louisiana tomorrow and one of my glow plugs took a dump on me. Yeah it’s minor but it kind of obnoxious having all these piddly things every time I try and take this truck somewhere. Got the tuning dialed in pretty good. She’s a little bit of a dog down low but she’s running clean. I was running down there pulling trailers with another guy that has a brand new F250 it had a little weight reduction done to it. I think he was a little caught off guard on how easily my truck kept up with his.
Last edited:
Well at least he only ate the wiring not the plug.... I’d rather solder in some new wire than have to replace the plug.
It was mostly the front bumper sensors. Then I found the def wiring jerked loose $380 to replace sensors and manual regen. I repaired 48 splice points, 2 sensors, fuel tank vent hose and 3 gallons of def fluid. I did not kill dogs but know hav e 13 mouse snap traps, 4 glue traps and 500 rounds of 22 Ammo. So far 2 chipmunks have perished.
Rotated my tires yesterday. Just did it at the house as I didn’t have time to go sit at discount tire. Go to reset tire pressure sensor sensors for positions and the damn thing will not learn positions using the “let air out” method. It honks at ya like it’s learning but based on the mdi2, it’s still trying to learn the RF sensor. Pissed me off, so I bought a cheap sensor delio off amazon to set them.
Can’t even rotate your damn tires without a computer.....
Can’t even rotate your damn tires without a computer.....
Finally ordered an atmospheric charger for my LB7. Settled on a race covered 480/96 from Joe at Danville/PMT
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Yep I found that out on my 2015. I just don’t bother unless I have time to stop by the tire shop.
The 10 dollar 433mhz antenna deal i bought off amazon worked like a charm this morning.
Next, there is going to be tamper proof bolts for the oil drain and one time use only oil fill caps
