I did front wheel bearings, ball joints and tie rods today. At 243,000 that stuff was wore out.
"OFFICIAL" What did you do to your D-Max today?
- Thread starter Hot COCOAL
- Start date
Ditched my impulse buy exhaust stack. Liked the look but the drone was annoying. It lasted a month :rofl:
Finally Pulled My intake Horn and started to port it.. I bought this 4-piece drum sanding kit.. Kit came with a 1inch 2 inch,3 inch and I think a 4inch.. I started with the 2inch and worked my way up to the 2 and half inch, I even slipped down and ported some of the elbow.. It has changeable sandpaper so use whatever grit you want.. Also have a boost valve to put on... My plan is to get it alittle over 2 and 3/4's right now Im at 2 and 5/8
Wow very nice work but you know you could have a better flowing system with a lot less work by using prefab mandrel bends.
Got my new T-stats in truck run at over 180* again. Yay for more heat. New jounce stops and idlers/belt to go.
Do you have stock suspension? As far as everything still at stock ride height?
New front diff, rear diff and engine oil change on the LB7, put it on jackstands and put it away in the garage 
Greased the LBZ and installed a deep pan, put the fender liners back in to get ready for the snow.
Started packing the LBZ up with all my crap. :thumb:
Greased the LBZ and installed a deep pan, put the fender liners back in to get ready for the snow.
Started packing the LBZ up with all my crap. :thumb:
Kansas bound?New front diff, rear diff and engine oil change on the LB7, put it on jackstands and put it away in the garage
Greased the LBZ and installed a deep pan, put the fender liners back in to get ready for the snow.
Started packing the LBZ up with all my crap. :thumb:
Stock never have touched the tbars CVs are almost flat. I just trimmed my to bumper fit my 285s.
Ok cool. I was curious when you get the new jounce in would you snap a pic to see how close they are? I don't fully understand the suspension but mine rides like a tank up front so wanted to compare and see if they are set close to correct
