Rob/ timdid u guys end up swapping the tcm or find a bad wire or what was the issue?
Or are ujustnot saying untill u knowits fixed for sure?
Or are ujustnot saying untill u knowits fixed for sure?
New Pulling Set up
- Thread starter Rhall
- Start date
I believe that the TCM was just bad. It was one I used for Mockup and never put the original back in the truck. So far no more communication codes and all seems to be working as planned...
I completely rewired the Engine harness to keep it off of the motor and put it around the back side of the engine. There is nothing on either valve cover. The computers are all relocated to the drivers side battery area to keep them away from the heat. The intakes make some of it a pain in the arse, but it seems to like moving lots of air....
I completely rewired the Engine harness to keep it off of the motor and put it around the back side of the engine. There is nothing on either valve cover. The computers are all relocated to the drivers side battery area to keep them away from the heat. The intakes make some of it a pain in the arse, but it seems to like moving lots of air....
Damn, I see now. Thanks for the pic. That does seem to be a decent sized charger....
edit: What kind of R's to get it lit?????
Im guessing it should be lit around 2800-3200, but its hard to tell for sure now, with little seat time, i havent even watched the gauges/dash that much.
Well, here is the first Video of the Caged Hooker... Ran good, but will run better.......
[YOUTUBE]XrhmcIYkxJ4[/YOUTUBE]
[YOUTUBE]XrhmcIYkxJ4[/YOUTUBE]
Last edited by a moderator:
Another great job as always Tim. Rob it must be a great time behind the wheel of that beast. :thumb:
How did you place this friday and did you end up making it down to clinton? I should have went to clinton only 45 minutes from home but oh well.
Got second Friday and Saturday night. Yep Clinton was nice. Heavy sled and pretty short track. Still needs some changes...
sounds great, nice runs!!
Did the un-lock switch work fine?
Yeah, it worked great! I forgot to tell you, thanks for calling me back that friday night a few weeks ago too!
Unlock switch worked great. Still trying to figure out our lack of RPM's though... Think that I might have it....
Here is the pull last night.
Clinton MO
http://www.youtube.com/user/timthecarman2004#p/u/0/umwVL73H55A
Here is the pull last night.
Clinton MO
http://www.youtube.com/user/timthecarman2004#p/u/0/umwVL73H55A