Is there away to check with the scan tool? Changing tunes results no change. Scan reads 4.98 volts when changing tunes. Any insight?
How do you know your dsp5 switch is Working?
- Thread starter DetailsUnlimited
- Start date
I would make sure when you open the dsp tune on your laptop that there are no out of range cells
sometimes you need to change tables for the correct voltage for each dsp tune
sometimes you need to change tables for the correct voltage for each dsp tune
Out of range ... Next to history? Is good should the voltage drop everytime I change tunes with the knob in scan tool?
Just found under upgrade OS. The currently loaded *.tune/ bin file operating system does not support custom op system upgrade using this option. What needs to be done?
I had a similiar issue when I did my DSP5. Can't remember exactly but somewhere near the last step (script) one or more of parameters got changed for reasons unknown. I recommend you go through those last steps and make sure those (three ?) PIDS are set correctly. It may have been the voltage settings returned to 0V for each tune on mine or the switch was disabled.
Yep, thought I had install wrong before and broke a pin off. Finally got it out and come to find out it was the right spot!
fixed the pin and its in there tight! I looked at scan tool and
Dsp5 tune and says nondsp
dsp5 volts 4.98-4.97
do i need to do something else? Im sure I missed a step or something easy?
fixed the pin and its in there tight! I looked at scan tool and Dsp5 tune and says nondsp
dsp5 volts 4.98-4.97
do i need to do something else? Im sure I missed a step or something easy?
EFI says You must have V7.6.0 build 94 or higher
and I have V7.5.6 build 133
I dont see this update on there site?
and I have V7.5.6 build 133
I dont see this update on there site?
I made the dsp tune using my race tune. Is there an order that they have to go in? Biggest tune to smallest? I have race, stupid street, tow, hot street and should not be on street. Haha