Guy on facebook sells a shaft that deletes everything from the stub out to the cv, but I don't drive mine on the street lol
Going for tens in the zf. (Mission Accomplished!!!)
- Thread starter zf>allison
- Start date
Guy on facebook sells a shaft that deletes everything from the stub out to the cv, but I don't drive mine on the street lol
Yeah, the H2 axle shaft goes in place of it, I was going to buy one, but not a good idea on a DD.
It's the only way to go on a race or pulling truck.
Must have not hit home when you said it lol. Aam had it listed for 98 i think but were out of stock.
Yeah they are the same, but I found a thread on here from 2 years ago where the one number worked for sure and a guy had ordered it and installed it so I figured safer to just use that number lol
That's the guy from Facebook. Went with fort Wayne clutch I think they have them in stock.
Got the new solid passenger side axle in. Road test was fun like always but was gonna do a launch from a stop and a damn pt cruiser snuck up behind me so just did a run from a gentle roll she ripped and 4x4 is working like a champ again.so tomorrow will be the first 4x4 launch on slicks with the new front axle so we will see if we find the next weak link or if she will move off the line. Billet wheel won't get done for this round but will be for the next race. Have one more after this in October and one in november.
12.3 at 118 ground 2 gears 1.69 60 foot cold trans
11.219 at 122 1.660 60 foot ground 6th
Dropping air running more
11.219 at 122 1.660 60 foot ground 6th
Dropping air running more