LMM: efi live help

[raycej]

i just boutght efi live and i was wondering if when you copied your stock tune on to your computer into the tuning suite if the truck is still driveable?

 

[8100 Power]

i just boutght efi live and i was wondering if when you copied your stock tune on to your computer into the tuning suite if the truck is still driveable?

Yes it is.

 

[raycej]

now when i try to pull my tune off of my truck it says it cannot connect to the interface any suggestions

 

[8100 Power]

now when i try to pull my tune off of my truck it says it cannot connect to the interface any suggestions

Download the latest software version from here:

http://forum.efilive.com/showthread.php?15958-Official-Public-Release-Mar-20-2011


Then try again. You'll also have to upgrade your Firmware and possibly your bootblock within the software.

 

[raycej]

thanks alot got it worked out had to reupload all the software to lab top

 

[raycej]

finally got my tunes back today was going to see if any one could help me out with flashing these into my truck with some tips?

 

[Torque Monster]

Open the tuning File you received and do a full flash if changing OS to DSP5/DSP2, do a quick flash if it is just a single tune.

 

[raycej]

so it just runs through the hand held into the ecm and shes done?

 

[raycej]

so i just copy the new tunes into the tune program then run it throught the handheld and it in my ecm ready to roll with a flip of the dsp5

 

[Torque Monster]

No. You need a laptop computer and the V2 simultaneously

Open the tuning file. It will open into the tune tool. from there there is a little red arrow to the far right corner at the top of the screen. That is a full flash. Click the arrow, it will display on screen instructions. Read through and follw them, and you will be golden. If you do not have a switch installed already it will revert to the base tune.

 

[raycej]

Man you guys rock thanks a million

 

[Torque Monster]

:thumb::hug:

 

[JoshH]

Just to clarify, in order to full flash, you must have the V2 plugged into the computer before you open the tune. Then at the top middlish of the screen there will be 3 buttons with arrows over computer chips. The first one will be a thin green arrow that goes to the right and turns up, this one is the download tune button. The next one will be a thin red arrow that goes right and turns down, this is the calibration flash (use this if you are not changing operating systems such as flashing in a single tune or making changes to your DSP tune that you have already flashed in). The last button will be a double line "fat" red arrow that points right and turns down, this is the full flash (this is what you use to change calibrations such as first installation of a DSP tune or going from DSP to a single tune). Just an FYI, you need to make sure you save your DSP tune somewhere safe. They cannot be downloaded out of the LBZ or LMM ECM.

 

[DMAX403]

Just an FYI, you need to make sure you save your DSP tune somewhere safe. They cannot be downloaded out of the LBZ or LMM ECM.

Yep, learnt that out the hard way!

 

[raycej]

just tried to reprogram my ecm and now it wont connect to the interface any ideas why?

 

[raycej]

GOT HER FIXED AND SHES A HAPPY GIRL!!!!!!:woott: