Has anyone had any experiences good or bad with DK Engine parts specifically their new cylinder heads?
http://dkengineparts.com/DK-GMLLY-CHL
http://dkengineparts.com/DK-GMLLY-CHL
DK Engine Parts
- Thread starter Silent One
- Start date
How have those DK Engine Parts heads held up now after a few years?
@Silent One did you end up going with some? If so, how have they been?
They have a pretty good deal on their brand new head sets so they're pretty tempting to try.
I've used quite a few sets of Fleece and Industrial injection loaded ready to go heads (they're reman) without an issue and they're both in the same ballpark price wise. If I were a betting man DK probably buys a bare casting from ProMaxx and then loads them.
And IF that's the case being from ProMaxx, is that a positive or negative thing??
Good to know on the Fleece/Industrial Injection. I have seen those options through my searching. Just didn't know if it's better to get a brand new set at that price or a reman'd set
Good to know on the Fleece/Industrial Injection. I have seen those options through my searching. Just didn't know if it's better to get a brand new set at that price or a reman'd set
ProMaxx seems to make some decent castings. Their Ford 6.0L heads have been pretty good for us whereas the 2x Cummins heads I've used from them where a total pain in the rear with holes not being tapped correctly, them forgetting some tapped plugs, and their casting having some shift where the intake horn wouldn't fit properly.
The keyword to my statement is an assumption. You would have to call them and ask who their castings come from.