:thumb:
Looks good, I'ld be interested.
Any idea on ballpark cost on spliced vs plug-n-play by the OBDII port?
Looks good, I'ld be interested.
Any idea on ballpark cost on spliced vs plug-n-play by the OBDII port?
custom adjustable integrated V2 mount!!!
- Thread starter duratothemax
- Start date
Ill have to look up where to find some male OBD plugs...probably an extra 15 bucks or so?? Those sorts of things are ridiculously expensive for what they are.
Nice bit of work there. :thumb:
I assume there is no locking tab on the male connector?
So gravity and the "ears" are holding the V2 onto the plug.
Have any trouble bouncing it off the connector?
I assume there is no locking tab on the male connector?
So gravity and the "ears" are holding the V2 onto the plug.
Have any trouble bouncing it off the connector?
carplugs.com has odbII parts, I was gonna wire in a extra obdII port until I saw this thread. Great Job by the way! Sent you a PM.:thumb:
Im still working on fine tuning the original rough prototype...Im getting a couple finalized versions done ASAP so I can start cranking them out. :thumb:
ill take one when you get it done, i have to leave mine hooked up so i can clear my agravating trans code.:rofl:
Whats a V2?
J/K.
Ben, as usual, you come up with another great idea. :thumb: You always amaze me.
J/K.
Ben, as usual, you come up with another great idea. :thumb: You always amaze me.
Last edited:
ok Im almost done with the jigs and 'tooling' to make the parts for these with consistency.
I also switched to a black wiring harness so it looks nicer/cleaner.
Would everyone just like them black? Otherwise, for a couple extra bucks I can color match them to your interior color (tan, gray, charcoal).
also trying to think of a name for it...anyone have any ideas?
ben
I also switched to a black wiring harness so it looks nicer/cleaner.
Would everyone just like them black? Otherwise, for a couple extra bucks I can color match them to your interior color (tan, gray, charcoal).
also trying to think of a name for it...anyone have any ideas?
ben
ok it looks like its going to be an extra 15-20 bucks or so for a completely plug and play setup, with a right angle OBD plug so its clean and doesnt stick out into your shin.
otherwise, you just splice into the wires behind the DLC (obd port)
otherwise, you just splice into the wires behind the DLC (obd port)
Most women I have known tell me black goes with everything...
How about "The V2 Bear Hug" (thinking of "don't feed the Ben" and the grabber ears...)
How about "The V2 Bear Hug" (thinking of "don't feed the Ben" and the grabber ears...)
Ben, Great idea. Are you sure you didn't graduate with a M.E. or Electrical Engineering degree
Good job.:thumb:
Actually, im an engineer "by trade" :rofl:
