ok so i have a dmax store trans kit in the truck, (ppe clutch pack kit, with ML converter) has been good for over a year. the other day i got into it and recieved an engine light. trans has no reverse, wont roll in neutral when running, and is tied up. pan looks clean and trim valve b moves freely in the valve body. is this an electrical problem that fryed my clutches? is it electrical problem that is energizing b solenoid when not needed? all of these codes came up and again after clearing them, they are mostly now gone except for ebcm performance and all wheel speed sensor codes? any help would be greatly appreciated thanks.
p0700-tcm request for mil
p0777 solendoid b stuck on
p0101 maf performance
p0380 glow plug circuit a
u1000 class 2 data link
c0035 left front wheel sensor
c0040 right front wheel sensor
c0055 rear wheel sensors
c0550 ecu performance ebcm
b1440 power mode master input circuits mismatch
b2615 pass compartment dimming lights
b2938? (bad handwriting) security sensor
u1016 lost communication with engine sensor
and one for key in ignition circuit
p0700-tcm request for mil
p0777 solendoid b stuck on
p0101 maf performance
p0380 glow plug circuit a
u1000 class 2 data link
c0035 left front wheel sensor
c0040 right front wheel sensor
c0055 rear wheel sensors
c0550 ecu performance ebcm
b1440 power mode master input circuits mismatch
b2615 pass compartment dimming lights
b2938? (bad handwriting) security sensor
u1016 lost communication with engine sensor
and one for key in ignition circuit