Bolt In Coilovers, Drop, Helper Bags, and other stuff Build
- Thread starter 408.Luke
- Start date
Thanks! But Jon at DBRods did most of the fab work and all the welding, I haven't gotten that good at it so I make him do it all :drool: His aluminum welds are the best!
Not one yet, they will only be available through DBRods once we finish testing. He's an official ridetech dealer and was the one who did all the research so you can only order these through him.
It's a Chassis/LS"x" performance shop here, right outside of Austin.
http://www.dbrodsandminis.com/
Btw the site hasn't been updated in awhile...
http://www.dbrodsandminis.com/
Btw the site hasn't been updated in awhile...
is there enough preload adjustment in those shocks to be used on a stock or leveled truck? or do they have a 2" longer coil spring in 1100 lbs rating?
i just spoke with the guy and im in line for a set. Card ready
Tell Rob to hurry up with my tune so I can test them already!
They don't, but I think we're going to use a 1 1/2" top cap so the spring will be lower. On mine I still have close to an inch of adjustment without any preload so that would net close to 2". Or I feel sure someone makes some spacers, the springs really aren't short enough to have any coil bind so you don't have to worry about that.
Do you have a "blocked" number? You need to leave a message, were trying to finish up a Fox body at the moment
