Search results

Search the forum Search Articles
  1. B

    question for you gentlemen.

    Figured I'd update. Every time I checked the reluctor wheel it was side to side play aka bolt backing out. Never thought to see if it rotated aka sheared pin. That's what it was so now going to finish taking it apart, using my stud gun to weld a pin onto it and hopefully slidehammer it out ..I...
  2. B

    new motor p0341 cam sensor performance code

    Did u ever figure out the problem
  3. B

    question for you gentlemen.

    Ok so I can get it idling. Kind of tricky how I have to do it. Have misfire in 1-2-4-5 Balance rate is 15 in those cylinders and -7 in the other's Pretty much have a dead pedal
  4. B

    question for you gentlemen.

    I know its bad but I plugged every sensor in like normal Disconnected passenger side charge pipe sprayed a small amount of brake clean it fired right up then died
  5. B

    question for you gentlemen.

    The only way I can get it fired up is to Disconnect lift pump Disconnect fuel pressure sensor It will fire up. Smokes and runs for about 15sec then dies If I connect the lift pump it will try and fire but wont it started once
  6. B

    question for you gentlemen.

    I only have a snapon solus It says pto engine shutdown yes Pto engage relay command on Pto feedback signal off Pto reset no
  7. B

    question for you gentlemen.

    I purchased this truck at an auction. So I don't know previous history just findin things out as I go along
  8. B

    question for you gentlemen.

    Even if i switch ecms the pto engine shutdown still says yes. Ill check the power to tcm
  9. B

    question for you gentlemen.

    Any other ideas im lost now..
  10. B

    question for you gentlemen.

    Still no go. Put ficm from known working truck and new oem cam sensor
  11. B

    question for you gentlemen.

    I appreciate the replies fellas. I figured if the ficm was bad the ecm wuth throw a code or something.
  12. B

    question for you gentlemen.

    See my ecm says it is communicating fine from what I can tell. I have no codes but the mil light is on.
  13. B

    question for you gentlemen.

    What was your buddies truck doing
  14. B

    question for you gentlemen.

    Ya I know what the ficm is just never seen one fail
  15. B

    question for you gentlemen.

    Only thing I havent tried is ficm and cam sensor. I just ordered a cam sensor Trying to locate a ficm..
  16. B

    question for you gentlemen.

    I shall try that next lol ive tried everything else. Reluctor wheels arent loose. New crank sensor installed as well
  17. B

    question for you gentlemen.

    Just took the ecm out. Tried another with vats relearn. Same issue. Only way I can get it to run for a few seconds is if I unplugg the fuel rail pressure sensor it will start for 10sec smoking like a chimney then die
  18. B

    question for you gentlemen.

    Security light comes on and turns right off
  19. B

    question for you gentlemen.

    Anyone have any ideas
  20. B

    question for you gentlemen.

    Checked pins at ecm connector and bail connectors All seem good. Had copperhead diesel re flash the ecm sean said everything looked normal Besides me seeing the pto engine shutdown yes
Top Bottom