Search results

Search the forum Search Articles
  1. Chad006

    Who else is going to UCC?

    I agree, baca only made 48hp more than firepunk but made 600 lb/ft more twist. I just think if it were myself I would detorque the tune a bit and make drivetrain parts live on the track for at least one pass to back up numbers.
  2. Chad006

    Who else is going to UCC?

    I think it's the fact that they have tried countless times to make a decent pass with multiple setups and a seemingly endless financial backing that gives the haters a leg to stand on. Don't get me wrong he clearly has the highest power truck in the ucc, I just don't understand why they can't...
  3. Chad006

    LLY: 12 mm stroker CP3

    If you plan on an engine build then yes, if not I would get a sportsman pump and forget about %125 overs.
  4. Chad006

    To AF or not?

    If you read my previous post you will see where I wrote that I don't believe that it's an absolute solution. But the af cams have been proven to improve harmonics, in most cases guys are swapping the stock can out for a more aggressive grind anyways. Why not install something that is ultimately...
  5. Chad006

    To AF or not?

    Do you have dyno sheets/timeslips of cams with same specs standard firing and alternate firing to back this up? I think there is allot more that goes into making power in these trucks than firing order alone. I'm. It saying that it's the answer at all but there has been vibration analysis...
  6. Chad006

    LBZ: Project "Cracked Piston"

    Nice! Every time I look at this thread I get all giggly for my build. Hoping to have it together by end of may. Pretty much exact same setup as yours.
  7. Chad006

    LML Intermittent Mis After DEF delete

    Here's the link to ppei's instructions for the delete. https://cdn.shopify.com/s/files/1/0254/3193/files/2015_LML_Duramax_AutoCal_Instructions.pdf?14529556546790486531
  8. Chad006

    LLY: This looks fun

    Nice it didn't break flush, ^^^ this, it works very well won't take much of a tack. Then skip the wrench and hit her with an impact it should go.
  9. Chad006

    Thinking maybe Nitrous

    Haha never thought of using the horn, I was just gonna run a remote momentary switch. Your lucky nobody ever hooked that horn back up on you. Would've made for a pretty comical 1/4 mile pass with the horn on. What was your fuel, air setup? I'm thinking I will have quite a bit of smoke to clean up!
  10. Chad006

    Thinking maybe Nitrous

    So I'm in the process of getting my new setup together, will be a SoCal motor, exergy 12mm stroker, exergy 100 over Lbz nozzles, sdp full billet trans and sdp 68mm 3794 and a billet s480 twins. My goal is to pull my fifth wheel to the track and then be able to bang off a Hail Mary 10.99. I...
  11. Chad006

    Duramaxzak 2.6 pulling truck build

    Less rotating mass? Just a guess I'm not a sled puller.
  12. Chad006

    Poverty awaits

    X3
View older results
Top Bottom