40% LBZ nozzles on LMM injectors in an LMM

[N2BRK]

since I picked up an extra hole, and yes that sounds dirty but it isn't :rofl:, this is surely more than 40 over. Does anyone know what this should be considered? 60 over?

TNX!

 

[Harbin_22]

I have been told an LBZ nozzle moves about 10% more than an LMM

 

[N2BRK]

ok, so a 44%; that's not much different. I was trying to figure out if one more hole (about 14% if all things are equal) was a 1:1 correlation or not. It sounds like it isn't quite. Thanks for the info!

 

[Harbin_22]

Don't take it to heart, but I was told from a reputable source lol. Might call Exergy and ask them

 

[THEFERMANATOR]

Just use an LBZ injector table as your base table, then yo don't have to account for the difference between LMM and LBZ.

 

[N2BRK]

I was told by George at Big Dipper that LBZ tables do not work when you have this combo. I guess the injectors for the LMM must be different enough from the LBZ, that even though the tips interchange you must have different flow.

I was trying to be sure that these are at least close to 40 over, and not more like 60, lol.

Thanks!