Search results

  1. silvrmax04

    LB7 Alternator Options in 2023

    20 yrs and 250k miles is a good run. I would buy the same one you have on there or have it rebuilt with Oem parts.
  2. silvrmax04

    ADII low pressure light

    Thanks. That’s exactly what I wanted to hear.
  3. silvrmax04

    ADII low pressure light

    I have an AD165 and the motor recently gave out. It was from 08 so can’t complain. Bought a new one and it’s much quieter. I could usually hear the old one when I turned the key forward. My question is will the light kit illuminate when the pump is not working even though it’s a flow thru on...
  4. silvrmax04

    Bfg Tko 285/70/17

    Wow. A lot less than I thought on an E rated tire. Thanks guys.
  5. silvrmax04

    Bfg Tko 285/70/17

    Anyone running these? Load range E. Max 80psi. Wondering what tire pressure to run for good wear and mileage. Currently at 65 front. 55 rear.
  6. silvrmax04

    DuramaxDiesel.com Stickers

    I would like a 1x9 in silver please.
  7. silvrmax04

    Questions regarding SAC injectors

    Talk to Brent at LDS. He talked me into the sac45. They have been out a lot longer and almost no failures or complaints. Also cheaper. I got the install kit also. He is very knowledgeable on them. Worth the call. I do need tuning though. Very peppy throttle but more smoke than I want.
  8. silvrmax04

    LB7 power steering fluid leak

    Just crawl under there and see where it is coming from. Wipe everything down then start it up. Take a short drive and see if you can find the leak.
  9. silvrmax04

    LB7 power steering fluid leak

    Sure if it’s the return line or even the supply draining out of the hose.
  10. silvrmax04

    LB7 power steering fluid leak

    most common place is one of the 3 hoses under the pump. Drivers side front. If so I would replace all 3.
  11. silvrmax04

    Front brake issues

    Took it for a short drive and all seems well just like it was before this all started. It was either everything on front needed changed or the abs. It was odd that the rotor and pads were not old and had a lot of meat left. Maybe a bad caliper led to the rotor and pads heating up and warped...
  12. silvrmax04

    Front brake issues

    Seems so. A shop had to cycle the abs. Now it pulls left slightly. He said it was my alignment and front end issues separate from the brake problem. It didn’t happen before. I since replaced the rotors and pads in front and tire spins more freely. He suggested it as it looked like stress cracks...
  13. silvrmax04

    Front brake issues

    I swapped pads from other side. Same result. I can also touch the pads and feel that the caliper is closed. Not tight but enough that the pads touch.
  14. silvrmax04

    Front brake issues

    Well, I jacked up front, swapped front pads. Same issue. Drivers side locking up. Opened line to fronts and still did not release. Went for 10 mile drive and no pulling while driving or braking but driver side is 40* hotter than pass. mostly at rotor. Not sure I want to chance a long drive. Made...
  15. silvrmax04

    Front brake issues

    Pads too thick? Same pads I had on there before this happened. Worth a shot will try tomorrow. Have to agree with Purehybrid that pads dragging that it would not have gotten that hot. Wheel would not spin to get that much resistance.
  16. silvrmax04

    Front brake issues

    Calipers, brackets and slides are all new. Hub spins fine without the caliper compressed. I guess I will look into the abs bleeding and try to cycle more fluid thru it in case air is trapped. Don’t know where to go from here except to take it to a shop. I am usually pretty good with brakes.
  17. silvrmax04

    Front brake issues

    Yes. New front flex hose. Also I have new SS lines installed a few years back. Getting good fluid out of calipers too. Only driver side doing it. I would say bad caliper but it would be odd that first one did this now a new one doing the same? I would think that if it was booster or master...
  18. silvrmax04

    Front brake issues

    So here is the story. I am sure someone has had this issue before. On the way home about 15 miles to go. Start to smell that brake smell. You know pads burning or fluid burning. Hoping it wasn’t me but of course it was. Didn’t seem to pull to either side while driving or hard braking. Pulled...
  19. silvrmax04

    Looking for Mower Advice

    If you want it for the attachments then your on the right track. If to cut lawn and plowing how about a zero turn and a separate plow , snowblower etc.