Recent content by melms23

  1. melms23

    chinese "bosch"?

    Is there a price cutoff thats likely a knockoff? I see $20-40 ones, $100-200 ones from the online diesel shops, then $250-400 ones that look legitimate. Are the $100 ones like josh mentioned the way to go? By the way I found bulk shipment of 1000+ for $1 each straight from china, no wonder...
  2. melms23

    chinese "bosch"?

    How did it hold up? I had a cheap 20 something one bad out of the box.
  3. melms23

    LML Hey Nerds! Wireless Charging Ideas Needed

    I put one on my 2015. I found a youtube video on it. Just get a decent one thats thin enough to fit and cut a hole for the usb cord to slip near the hinge and plug in.
  4. melms23

    Air bags

    X2. I will add that our LML has bags just inside the tire on the outside of the frame. I like this style better than the ones that replace the bumpstop between the frame and axle. They seem to ride better unloaded.
  5. melms23

    LML Starter grind

    I thought so but hadn't kept up on the lml trucks. Thanks
  6. melms23

    LML Starter grind

    Our '11 LML has ground the starter every so often and is getting more frequent. Going to replace the starter and flywheel. Can I use one from an LBZ? I have the flywheel left over from another project. The truck is all stock and has 115k on it.
    • melms23
    • Thread
    • Replies: 2
    • Forum: LML
  7. melms23

    2014 lml no start intermittent

    edit: I'll try that. Hate it when people log in once and don't give any follow up.
  8. melms23

    2014 lml no start intermittent

    Any update with this? We have had the same issue. We drove 2 hours to the truck to put new batteries in (my sister drives it) got there and fired right up. Both batteries test out good.
  9. melms23

    LBZ pedal connector

    Just to clarify, is this for a lbz swap into lly/lb7 or can you stick a lbz pedal in an lly? I've always like the plastic pedal better.
  10. melms23

    ZF6 cooling needed

    I was told once to bump the idle up once by a friend to make it easier to take off without killing. I hated it, and made it jerky and hard to keep steady. I found lowering the idle allowed me to ride the clutch more and actually easier taking off and backing up.
  11. melms23

    ZF6 cooling needed

    I found lowering the idle did wonders for being able to back trailers up nicely in 2wd in my rclb. A little heavier truck like yours would probably be a little smoother backing up with the dual disc clutch.
  12. melms23

    Fuel tank mod for more fuel

    I have 2 steel L tanks and a few square tanks, but your a little far James :roflmao:
  13. melms23

    LLY: Hood Options

    Could do a 01-02 hd hood cut to fit the GMC lights. I always have liked the looks of them.
  14. melms23

    LBZ: Hi from WI

    Both were rclb LLY, one a zf6 which i sold. Both have been great. No rust at all.
  15. melms23

    LBZ: Hi from WI

    Welcome, I'm from Wisconsin also and have bought a couple trucks from Denver.
See more
Top Bottom